Hayter 447F - Manual - manualsarea.com

Page 2 - Introduction; Important; Note; Contents

This product complies with all relevant Europeandirectives, for details please see the separate productspecific Declaration of Conformity (DOC) sheet. Introduction Thank you for purchasing a Hayter mower. Thefollowing pages are designed to help you gain safe andefficient service from your machine Th...

Page 3 - Safety; General Lawn Mower Safety; Training; WARNING; Preparation

Safety Improperly using or maintaining this mower canresult in injury. To reduce the potential for injury,comply with these safety instructions. This mower was designed and tested for reasonably safeservice; however, failure to comply with the followinginstructions may result in personal injury. To ...

Page 4 - Maintenance and Storage; will fit; parts and; Sound Pressure

– Do not mow excessively steep slopes. – Exercise extreme caution when on slopes. – Mow across the face of slopes, never up and down and exercise extreme caution whenchanging direction on slopes. – Always be sure of your footing on slopes. • Use low throttle settings when engaging thetraction-clutch...

Page 5 - Safety and Instructional Decals

Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. Manufacturer’s Mark 1. Indicates the blade is identified as a part from the originalmachine manufacturer. 110-7058 1. Height of cut 110-7059 Model 447F only 1....

Page 6 - Setup; Unfolding the Handle; Filling the Engine with Oil; Slowly; Change the engine oil after the first; Refer to Changing the Engine Oil.

Setup Unfolding the Handle 1. Unlock the handle locks, move the handle sections into the operating position, and lock the handle locks(Figure 3). Figure 3 2. Unlock the upper handle locks and rotate the upper handle upward and lock it into a position that iscomfortable to you (Figure 4). Figure 4 1....

Page 7 - You cannot start the mower with the

Installing the Fuse (Model447F Only) Your mower comes with a 40-amp fuse that protects theelectric starter. Important: You cannot start the mower with the electric starter or charge the battery unless youinstall the fuse. 1. Remove the battery cover and the battery and locate the fuse holder (Figure...

Page 8 - Product Overview; Operation; Filling the Fuel Tank; To reduce starting problems, add; Checking the Engine Oil Level; slowly

Product Overview G01201 1 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Figure 9 Model 447F shown 1. Lower handle lock 8. Rear door 2. Grass bag 9. Oil fill/Dipstick (not shown) 3. Upper handle lock 10. Fuel tank cap 4. Recoil start handle 11. Cutting height lever (2) 5. Upper handle 12. Spark plug 6. Blade cont...

Page 9 - Adjusting the Cutting Height; Starting the Engine; Using the Self-propel Drive

detergent oil with an API service classification ofSF, SG, SH, SJ, SL, or higher.) 3. Install the dipstick. Adjusting the Cutting Height Adjusting the cutting height may bring you intocontact with the moving blade, causing seriousinjury. • Stop the engine and wait for all moving partsto stop. • Do n...

Page 10 - Stopping the Engine; When you release the blade control; Recycling the Clippings; recycling; Bagging the Clippings; bagging; Installing the Grass Bag

sides, and the mower will automatically keep pace withyou. Figure 15 Stopping the Engine 1. Release the blade control bar (Figure 16). Figure 16 2. When the engine stops, remove the ignition key when you leave the mower. Important: When you release the blade control bar, both the engine and blade sh...

Page 11 - Removing the Grass Bag; Operating Tips; General Mowing Tips

G008083 Figure 18 Removing the Grass Bag To remove the bag, reverse the steps above. Rear-discharging theClippings Use the rear discharge for cutting very tall grass. If the bag is on the mower, remove it (refer to Removingthe Grass Bag) before rear-discharging the clippings(Figure 19). The Recyclin...

Page 12 - Cutting Leaves

– Raise the cutting height on your mower. – Cut the grass more frequently. – Overlap cutting swaths instead of cutting a full swath with each pass. – Set the cutting height on the front wheels one notch lower than the rear wheels. For example,set the front wheels at 60 mm and the rearwheels at 70 mm...

Page 13 - Maintenance; Preparing for Maintenance; Before tipping the mower to change

Maintenance Recommended Maintenance Schedule(s) Maintenance Service Interval Maintenance Procedure After the first 5 hours • Change the engine oil. Before each use or daily • Check the engine oil level.• Ensure that the engine stops within 3 seconds after releasing the blade control bar.• Clean the ...

Page 14 - Lubrication; Lubricating the Wheel Gears; rear; Engine Maintenance; Replacing the Air Filter

Lubrication Lubricating the Wheel Gears Service Interval: Yearly—Lubricate the wheel gears. 1. Remove the wheel bolts on the rear wheels and remove the rear wheels. 2. Apply a lubricating oil to the gear as shown in Figure 21. Figure 21 3. Install the rear wheels. Engine Maintenance Replacing the Ai...

Page 16 - Adjusting the Self-propel Drive

Drive SystemMaintenance Adjusting the Self-propel Drive If your mower does not self-propel properly, adjust theself-propel drive cable. 1. Loosen the nut on the cable mount (Figure 25). Figure 25 1. Nut on cable mount 2. Pull the upper handle back fully rearward (Figure 26). Figure 26 3. Pull the ca...

Page 17 - Blade Maintenance; Replacing the Blade; You will need a torque wrench to install; . If you do not have a torque; Position the curved ends of the

Blade Maintenance Replacing the Blade Service Interval: Every 25 hours—Replace the bladeor have it sharpened (more frequentlyif the edge dulls quickly). Important: You will need a torque wrench to install the blade properly . If you do not have a torque wrench or are uncomfortable performing thispro...

Page 18 - Cleaning; Cleaning the Mower; Storage; Petrol vapors can explode.

Cleaning Cleaning the Mower Service Interval: Before each use or daily—Clean the mower. Tipping the mower may cause the fuel to leakfrom the carburetor or the fuel tank. Petrolis extremely flammable, highly explosive, andunder certain condition can cause personalinjury or property damage. Run the en...

Page 24 - Code Serial No.

CUS TOME R INFO RMATION Date of Sale:-Your Local Dealer:- HAYTER L IMITED, SPELLBROOK, BISHOP’S STORTFORD, HERTS. CM23 4BU, ENGLAND Code Serial No.