Page 3 - CONTENTS; SAVE THESE INSTRUCTIONS
CONTENTS 1 SAFETY AND WARNINGS INSTALLATION INSTRUCTIONS CONTROL PANEL USING YOUR DRYER CLEANING YOUR DRYER TROUBLESHOOTING IMPORTANT! SAVE THESE INSTRUCTIONS Please read these instructions carefully before using your tumble dryer. The instructions contain important information which will help you g...
Page 4 - SAFETY AND WARNINGS; Fire Hazard; IMPORTANT SAFETY INSTRUCTIONS; Dryer use
SAFETY AND WARNINGS 2 ! WARNING! Fire Hazard ■ Only dry fabrics that have been washed with water. ■ Do not use heat t o dry articles c ontaining f oam rubber or similarly textured rubber–li ke m at erials, dry on ‘Air ing ’. ■ Do not st op a tumble clothes dr y er bef o re the end of the drying unle...
Page 5 - Lint
SAFETY AND WARNINGS ■ Do not operate this product without the lint filter in place or allow lint to accumulate in or around the dryer. ■ This dryer is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unle...
Page 6 - Spontaneous combustion
SAFETY AND WARNINGS Spontaneous combustion IMPORTANT! To reduce the risk of fire in a tumble dryer the following should be observed: ■ Items that have been spotted or soaked with vegetable oil or cooking oil are a fire hazard and should not be placed in a tumble dryer. ■ Oil-affected items can ignit...
Page 7 - INSTALLATION INSTRUCTIONS; Please read and follow the ‘Safety and warnings’ and ‘Installation
INSTALLATION INSTRUCTIONS Please read and follow the ‘Safety and warnings’ and ‘Installation instructions’ sections carefully before using your dryer. Unpacking 1 Remove all the packaging. 2 Tilt the dryer backwards and ‘walk’ it off the base one foot at a time. 3 Remove all packaging and accessorie...
Page 8 - Venting; from appliances burning gas or other fuels.; External venting; Eliminates condensation on walls and ceilings.; The external venting system should be:
INSTALLATION INSTRUCTIONS Venting Correct installation is very important for all dryers to ensure maximum efficiency and safety. IMPORTANT! Never run the dryer unless the airflow system is free from obstruction. There must be adequate ventilation to avoid the back flow of gases into the room from ap...
Page 9 - Free standing
INSTALLATION INSTRUCTIONS Free standing The dryer stands on the floor and can easily be moved into position. 1 Move the dryer into the desired position. Do not lift the dryer by the top panel. 2 Have a minimum clearance on all sides of at least 20mm. 3 Have a minimum clearance at the rear of 75mm. T...
Page 10 - Mounting dryer on wall; the lid of the washer.
INSTALLATION INSTRUCTIONS Mounting dryer on wall 1 Determine the position of the dryer on the wall and mark the bracket position. A minimum of 50mm is needed between the top of the dryer and the ceiling for ease of installation. If mounting above a washing machine, allow sufficient room to open the ...
Page 11 - Stacking installation; ■ The models of Haier front load washing machine that
INSTALLATION INSTRUCTIONS Stacking installation Your dryer has been designed to be able to be stacked on the top of a Haier front load washing machine, ensure the washing machine is the same width as your dryer. Tools and parts required: ■ Drill and 2.9mm bit ■ Phillips head screwdriver 1 Remove 4 s...
Page 12 - Internal venting; Hose connector
INSTALLATION INSTRUCTIONS Before a rear venting option is installed the dryer must be changed from the front venting factory setup. Remove the outlet grille from the front left-hand side and replace with the outlet cover from the rear left-hand side. These covers should be gently pried at the sides ...
Page 13 - Product specifications; Electrical connection; electrical supply.
INSTALLATION INSTRUCTIONS Product specifications HDV60A1 HDV40A1 Capacity (kg)* 6 DIMENSIONS (mm) Width 600 Depth 585 Height 830 ELECTRICAL Volts 220-240 Hz 50 Amps (maximum) 10 Rated Power (W) 1750 4 600495830 220-24050 101750 Waterproof degree IPX4 IPX4 * Capacity refers to the maximum dry weight ...
Page 14 - CONTROL PANEL; A Start / Pause button; press the; B Indicator light; you start the cycle. It will flash rapidly if a fault occurs.; C Control dial; wrinkling and creasing for 1 hour or until door is opened.
CONTROL PANEL A Start / Pause button After selecting your desired drying cycle by turning the cycle knob, press the ‘Start / Pause’ button to start the cycle, and press it again to pause the cycle. B Indicator light The light will flash when you select a cycle, and it will stop flashing and remain l...
Page 15 - USING YOUR DRYER; Preparing your load
USING YOUR DRYER IMPORTANT! ■ Check the lint filter is clean before every load. Ensure it is replaced correctly before using your dryer. ■ Sort and load items into the dryer drum, ensuring no items are in the way of the door. ■ Close the door. ■ Ensure your dryer connect to an appropriate power supp...
Page 16 - Select you desired drying cycle by turning the; ■ Failure to follow the ad; ■ Unplug the dryer from the power socket.
USING YOUR DRYER Selecting program Select you desired drying cycle by turning the control dial. Start the dryer Press ‘Start / Pause’ button to start your dryer. Complete the cycle When the cycle finishes, your dryer will stop rotating and the indicator light will flash, you can open the door and re...
Page 17 - CLEANING YOUR DRYER; ■ The lint filter is located in the door opening (at the bottom).
CLEANING YOUR DRYER Cleaning your dryer Before you start cleaning your dryer, ensure that it is disconnected from the power (ie unplug the dryer from the power socket). Cleaning the control panel and outer surfaces of the dryer Use a soft damp cloth to wipe all surfaces, then wipe dry. Avoid using c...
Page 18 - TROUBLESHOOTING; Troubleshooting; please contact your Haier Repairer.
TROUBLESHOOTING Troubleshooting The following is a list of problems you may encounter when using this appliance and some suggestions that may help to correct the problem. If you still have problems, please contact your Haier Repairer. PROBLEM POSSIBLE CAUSES WHAT TO DO Dryer stops working mid-cycle....