Grizzly Industrial T10252 - Manuals

Grizzly Industrial T10252 – Manual in PDF format online.

Manuals:

Manual Grizzly Industrial T10252

1 Page 1
2 Page 2
3 Page 3
4 Page 4

Summary

Page 2 - Figure 4; The two inner screws of the four-screw; Installation; Tools Needed; Go to Grizzly.com or call Customer Service; To install the dust port onto the sander:

-2- t10252 dust port 3. With the help from another person to steady the sander, tip it back to gain access to the two cap screws underneath the base that secure the lower blade guard, then remove these cap screws (see Figure 4 ). 4. remove the eight phillips head screws behind the guard that secure ...

Page 3 - Figure 7; It may be necessary to gently tap on; Lower

t10252 dust port -3- Figure 5. phillips head screws that secure and adjust the guard sections. phillips head screws (1 side shown) Figure 6. removing the upper disc guard. upper disc guard 5. Fully loosen the two set screws that secure the disc to the motor shaft, as shown in Figure 7 . 6. take care...

Page 4 - Figure 5

-4- t10252 dust port 13. Make sure the disc is fully seated on the motor shaft, then re-tighten both set screws to secure it. 14. re-install the upper disc guard with the eight phillips head screws that you removed in Step 4 . 15. thread the inner two screws from Step 10 in or out to adjust the uppe...

Grizzly Industrial Manuals