Grizzly Industrial H8110 - Manuals

Grizzly Industrial H8110 – Manual in PDF format online.

Manuals:

Manual Grizzly Industrial H8110

1 Page 1
2 Page 2
3 Page 3
4 Page 4

Summary

Page 2 - Using a 5mm hex wrench, thread the bolts; not fully tighten at this time.; figure 15. Upper cross panel installation.; ously installed cross braces.; position the left side leg (B) on the floor so; Carefully engage the slots in the left leg with

-2- model h8110 (mfg. since 7/09) E C F E figure 13. Lower panel installation. 5. place a flat washer (e2) on each barrel bolt (e3), and insert the bolts through the right-side leg ( figure 12). 6. Using a 5mm hex wrench, thread the bolts into the barrel nuts (e4) ( figure 12), but do not fully tigh...

Page 3 - until they are fully seated in the grooves.; Rotate

model h8110 (mfg. since 7/09) -3- 14. insert the bolts through the left-side leg, tighten with a 5mm hex wrench, and all other barrel bolts at this time. 15. align the pre-drilled holes in the underside of the work bench table top (a) with the pre-drilled holes in the legs. 16. place a flat washer (...

Page 4 - parts Breakdown and Inventory; parts; FLat Washer 8mm

-4- model h8110 (mfg. since 7/09) parts Breakdown and Inventory parts fastener Kit part Numbers QTY ph8110001 handLe sCreW 18 pW01m FLat Washer 8mm 12 ph8110003 BarreL BoLt 3.5" 8 ph8110004 BarreL nUt 8 ph8110005 handLe 9 paW05m heX WrenCh 5mm 1 paW04m heX WrenCh 4mm 1 ph8110008 Wood sCreW 2"...

Grizzly Industrial Manuals