Garland CG-72F - Manuals - manualsarea.com

Page 2 - IMPORTANT INFORMATION; california to cause birth defects or other reproductive harm.; Keep appliance area free and clear of combustibles.

Part # 4520498 (01/08) Page 2 IMPORTANT INFORMATION WARNING: This product contains chemicals known to the state of california to cause cancer and/or birth defects or other reproductive harm. Installation and servicing of this product could expose you to airborne particles of glass wool/ceramic fiber...

Page 3 - TABLE OF CONTENTS

Part # 4520498 (01/08) Page TABLE OF CONTENTS IMPORTANT INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 DIMENSIONS AND SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 INSTALLATION . . . . . . . . . . . . . . . . ....

Page 4 - Serial Plate Location

Part # 4520498 (01/08) Page 4 DIMENSIONS AND SPECIFICATIONS INSTALLATION IMPORTANT: The installation must comply with local codes, or in the absence of local codes, with CAN/CSA - B149 Installation Code – latest edition or with the National Fuel Gas Code NFPA 54 ANSI Z22 .1 – latest edition . All bu...

Page 5 - INSTALLATION Continued

Part # 4520498 (01/08) Page 5 NOTE: The griddle plate may not rest evenly on the unit body if the unit is not properly leveled . 5 . Each caster has a threaded stem to aid in leveling only . No caster should be adjusted beyond a maximum of one-half inch, (1/2”/1mm) of exposed thread with the locking...

Page 6 - Electrical Connection

Part # 4520498 (01/08) Page 6 INSTALLATION Continued 4 . The appliance must be isolated from the gas supply piping system by closing its individual manual shut off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 PSIG . ( .45 KPA) . 5 . Ma...

Page 7 - OPERATION INSTRUCTIONS; Lighting Instructions; ADJUSTMENTS; Pilot Adjustment

Part # 4520498 (01/08) Page 7 OPERATION INSTRUCTIONS Lighting Instructions 1 . First, make certain that the main power switch is set to “OFF” 2 . Connect an electrical power cord to 120 volt supply . . Turn the gas shut off valve to the “OPEN” position (valve handle in line with piping) . 4 . Turn t...

Page 8 - ADJUSTMENTS Continued; Thermostat Temperature Verification

Part # 4520498 (01/08) Page 8 ADJUSTMENTS Continued Drawing A Place the probe within a 1 1/2 " circle for maximum accuracy 5 7/8" 12" 12" 12" 10" NOTE: Make certain no electrical connections have been disturbed . Replace both panels and secure to body . The griddle thermostat...

Page 9 - MAINTENANCE & CLEANING; Stainless Steel

Part # 4520498 (01/08) Page 9 MAINTENANCE & CLEANING Stainless Steel Stainless steel should be cleaned using a mild detergent, a soft cloth and hot water . If it is necessary to use a non- metallic scouring pad, always rub in the direction of the grain in the metal to prevent scratching . Wash a...

Page 10 - MAINTENANCE & CLEANING Continued; SERVICING

Part # 4520498 (01/08) Page 10 MAINTENANCE & CLEANING Continued Don’ts 1 . Do not use salt to clean the griddle surface . Salt is corrosive and can cause pitting of the griddle . 2 . Do not allow metal utensils (Spatula, scraper, etc .) to nick and/or dent the surface of the griddle . The edges ...

Page 11 - TROUBLE SHOOTING GUIDE

Part # 4520498 (01/08) Page 11 TROUBLE SHOOTING GUIDE PROBLEM CHECKS REQUIRED ACTION REQUIRED 1 . No Heat Is cord set plugged into receptacle? Connect cord to receptacle or check fuse/ breaker Is Manual Gas Valve turned to “ON”? Turn Manual Gas Valve to “ON” Is Main Power switch indicator illuminate...