Fujitsu FMC-16LX/FR - Manuals

6 1 C1+ 3 C1- 4 C2+ 5 C2- 11 T1IN T1OUT 14 10 T2IN T2OUT 7 12 R1OUT R1IN 13 9 R2OUT R2IN 8 2 +V 6 -V 1 SIN 2 NC 3 MD0 4 GND 5 MD2 6 SOT 7 Pxx 8 Pyy 9 +Vcc 10 NC 1 CD 2 RD 3 TD 4 DTR 5 GND 6 DSR 7 RTS 8 CTS 9 RI C1 100nf C4 100nf C2 100nf C3 100nf SW1 To Target Board T o PC Serial Port +5V Figure 2: ...

7 The following steps are required to set up the Hardware and software of the flash programming adapter. 1. Download the FLASH programming utility from the CD. 2. Connect one side of the ribbon cable to Adapter (J1) and other side to the user target board (Note: The user board should have the 10-pin...

8 In order to connect the adapter cable to the target board, it is required to have the 10-pin standard IDC header on the target board with the connection shown below. Figure 3 shows the connections from the microcontroller to header. For detail pin out refer to Appendix A/B. Note: • Pull up and pul...

9 Pin No. Description Details 1 SIN/SI Connected to the SIN of the Microcontroller. Refer table-2 shown below. 2 NC 3 MD0 Connected to the MD0 pin of the MCU 4 GND Ground of the Target board and MCU 5 MD2 Connected to the MD2 pin of the MCU 6 SOT/SO Connected to the SOT of the Microcontroller. Refer...

11 Microcontroller pins used for Serial Programming