Fujitsu D1321 - Manuals - manualsarea.com

Page 7 - Contents

A26361-D1321-Z120-1-7419 Contents Introduction ........................................................................................................................................ 1 Notational conventions ..............................................................................................

Page 9 - Introduction; Notational conventions; Text in this bold typeface; Important notes

A26361-D1321-Z120-1-7419 English - 1 Introduction i Depending on the configuration chosen, some of the hardware components describedmay not be available on your system board. You will find further information in the "BIOS Setup" description. Further information about drivers is provided in t...

Page 10 - Information about boards

Important notes 2 - English A26361-D1321-Z120-1-7419 The shipped version of this board complies with the requirements of the EECdirective 89/336/EEC "Electromagnetic compatibility". Compliance was tested in a typical PC configuration. When installing the board, refer to the specific installa...

Page 11 - Features

Features A26361-D1321-Z120-1-7419 English - 3 Features The components and connectors marked are not necessarily present on the system board. • System board in µ ATX format • mPGA478 Intel processor Pentium 4 with 400 MHz Front Side. Pentium 4 processors support MMX technology and Intel Streaming SIM...

Page 12 - External ports

Features 4 - English A26361-D1321-Z120-1-7419 • 1 AGP slotThe AGP slot supports 1x, 2x and 4x AGP mode. Only AGP boards with 1.5 V are supported. • IDE hard disk controller connected to PCI bus for up to four IDE drives(e.g. IDE hard disk drives, ATAPI CD-ROM drives)The IDE hard disk controller are ...

Page 13 - Internal ports and connectors

Features A26361-D1321-Z120-1-7419 English - 5 Internal ports and connectors DIMM 2 PC I 2 PC I 3 PC I 1 AG P DIMM 1 DIMM 3 1 2 3 4 5 7 6 8 9 10 11 12 13 14 1 = Power supply ATX2 = Floppy Disk Drive3 = IDE drives 3 and 4 (secondary)4 = Connector for control panel and loudspeaker 5 = IDE drives 1 and ...

Page 14 - Hard disk connection; PCI bus interrupts

Features 6 - English A26361-D1321-Z120-1-7419 Hard disk connection An ultra ATA/66 or ultra ATA/100 hard disk must be connected with a cable especially designed forthe ultra ATA/66or ultra ATA/100 mode. Ê Connect the end of the cable marked with blue to the system board. LAN connector This system bo...

Page 15 - Settings with switches and jumpers; off; off; Recovering System BIOS - switch 2

Settings with switches and jumpers A26361-D1321-Z120-1-7419 English - 7 Settings with switches and jumpers 1 2 3 4 ON Switch 1 = must always be set to off Switch 2 = System BIOS recoverySwitch 3 = must always be set to off Switch 4 = must always be set to off i The clock frequency of the processor i...

Page 17 - Installing and removing processors

Add-on modules A26361-D1321-Z120-1-7419 English - 9 Installing and removing processors 3 2 1 A 4 5 3 2 1 A 4 5 Ê Pull the lever in the direction of the arrow (1) and lift it as far as it will go (2). Ê Remove the old processor from the socket (3). Ê Insert the new processor in the socket so that the...

Page 18 - Upgrading main memory; Installing a memory module; Removing a memory module

Add-on modules 10 - English A26361-D1321-Z120-1-7419 Upgrading main memory These slots are suitable for DIMM format 32, 64, 128, 256, 512, 1024 MB SDRAM memorymodules. Memory modules with different memory capacities can be combined. ! You may only use unbuffered 3.3 V memory modules. Buffered memory...

Page 19 - Installing network board with WOL

Add-on modules A26361-D1321-Z120-1-7419 English - 11 Installing network board with WOL Ê Install the network board as described in the operating manual for your unit. Ê Push the WOL cable onto the WOL plug connector of the system board. i To use the WOL functionality of a network board the power sup...

Page 20 - Replacing the lithium battery

Add-on modules 12 - English A26361-D1321-Z120-1-7419 Replacing the lithium battery ! Incorrect replacement of the lithium battery may lead to a risk of explosion. The lithium battery must be replaced with an identical battery or a battery typerecommended by the manufacturer (CR2032). Do not throw li...

Page 21 - Glossary

Glossary A26361-D1321-Z120-1-7419 English - 13 Glossary The technical terms and abbreviations given below represent only a selection of the full list ofcommon technical terms and abbreviations.Not all technical terms and abbreviations listed here are valid for the described system board. ACPI Advanc...