Dish Network DP21 - Manuals

Page 3 - Contents; Operating with a DishPro

3 Contents Introduction ..................................... page 4 How to Install the DP21 Switch ..... page 5 Operating with a DishPro Compliant Splitter ..................... page 10 Wiring Diagrams ............................. page 10 Limited Warranty ............................ page 14 Instr...

Page 4 - Introduction

4 Introduction A DishPro 21 (DP21) Multi-Dish Switch allows you to receive signalsfrom two DishPro LNBFs, and route these signals to a DishPro satellitereceiver (see page 10 for wiring diagrams). This guide explains how to install a DP21 Multi-Dish Switch. Use thisguide along with the DishPro Instal...

Page 5 - How to Install a DP21 Switch; Check Switch; Satellite In; Connections; To Receiver Satellite In; Note

5 How to Install a DP21 Switch The following instructions assume you have alreadypointed your dish for the strongest possible signal, that youhave run Check Switch with the DishPro LNBF connected directly to the receiver ’s Satellite In port, and that you have taken a software upgrade from the satel...

Page 6 - Run Check Switch

6 2. Connect the coaxial cables from a DISH 500 or a DISH 300 to theports on the DP21 switch labeled To Dish as shown in the wiring diagrams that begin on page 10. 3. Connect the cable from the satellite receiver port labelled Satellite In to the DP21 port labeled To Receiver Satellite In . Run Chec...

Page 9 - Installation Summary; Satellite reception verified

9 Figure 3. Installation Summarywithout Identified Devices 5. If the Installation Summary does not show that Check Switch completed successfully as shown in step 4, check your connectionson all cables at the receivers, switches, and LNBFs, and then runCheck Switch again. 6. If you still do not see t...

Page 10 - Operating with a DishPro Compliant Splitter; Wiring Diagrams

10 7. If you still do not see the Satellite reception verified message, call the DISH Network Customer Service Center at 1-800-333-DISH (3474). Operating with a DishPro Compliant Splitter When using a DishPro compliant splitter to split the signal from aDishPro single LNBF (as shown in Figures 4 and...

Page 14 - Limited Warranty

14 Limited Warranty This warranty extends only to the original user of the DISH Network ™ DP21 Switch (“you,” “your”) and is limited to the purchase price of the switch.EchoStar Communications Corporation and its affiliated companies (“we,” “our,”“us”) warrant this switch control against defects in ...

Page 15 - Advance Exchange Program

15 USE OF, OR INABILITY TO USE, THIS DEVICE. UNDER NOCIRCUMSTANCES SHALL OUR LIABILITY, IF ANY, EXCEED THEPURCHASE PRICE PAID FOR THIS DEVICE. EXCEPT TO THE EXTENTPROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OFMERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ONTHIS DEVICE IS LIMITED IN DURA...

Page 16 - Post Receipt Exchange Program

16 The shipping charge, for receiving replacement equipment and returning thedefective equipment, is a one time fee based on EchoStar's competitive bulkshipping rates (additional charges may apply outside of the continental US). Thisfee will be charged to your billing account or your valid credit ca...

Page 18 - FCC Information

18 We will: Check the switch, including whether it is covered under the warranty. Replace any switch that we find is defective with a new or refurbished switch, ifthe defective switch is covered under the warranty. We will ship the replacementswitch at our expense. If a defective switch is not cover...