Dish Network 942 - Manuals

Remote Controls 61 Controlling Other Components Installing a UHF Attenuator Unwanted UHF signals may interfere with signals from the remote control to the receiver. To prevent such interference, you can install a 10 dB attenuator (available from many consumer electronics parts stores). Adding this a...

Chapter 9 62 Controlling Other Components Remote Control Modes Use the remote control’s mode buttons, SAT (satellite receiver), TV (for a TV), VCR (for a VCR or a DVD player), and AUX (“auxiliary,” for a second TV, a VCR, a tuner, an audio amplifier, or a second DISH Network satellite receiver) to s...

Remote Controls 63 Controlling Other Components Setting Up Using Device Code Tables Set up the remote to control other devices using the device codes listed on page 116. In the instructions below, the column on the left contains the instructions and the column on the right provides additional inform...

Chapter 9 64 Controlling Other Components Setting Up Using Device Codes Scan If the code for your device is not listed in the tables starting on page 116, use this procedure to scan the remote control’s memory for the device code. In the instructions below, the column on the left contains the instru...

Remote Controls 65 Controlling Other Components Checking the Device Codes You can find out what device code you’ve set for each remote control mode (TV, VCR, and AUX) . Instructions Additional Information 5 Press the UP or DOWN ARROW repeatedly until the device turns off. As you press the UP or DOWN...

Chapter 9 66 Controlling Other Components Controlling a Tuner/Amplifier Use the following remote control buttons to control a tuner or amplifier. When the remote control is set up as described on pages 61 and 67, press the AUX mode button to set the remote to AUX mode. The AUX mode button will stay ...

Remote Controls 67 Controlling Other Components Switching Between TV and Device Volume Adjustment When the remote control is setup to operate your TV, the VOLUME and MUTE buttons adjust your TV volume. If you prefer the volume and mute functions of the remote to adjust the volume of a remote-control...

Chapter 9 68 The Recover Button 1 Turn on the other receiver and display the System Info screen as described in the user’s guide for information on how to display the screen). Write the address: 2 Press and hold AUX until all the other mode buttons light up, and then let go of the button. AUX flashe...

Remote Controls 69 The Recover Button Programming the Recover Button for Remote Control 2 When your Remote Control 2 is shipped from the factory, RECOVER is set up to restore satellite TV viewing by tuning your TV (or VCR) to channel 3, 4, and other inputs. However, to use RECOVER with your remote T...

Chapter 9 70 Sending Discrete Power On and Off Removing the Recover Button Channel Programming The following instructions describe how to reset RECOVER to restore satellite TV viewing by tuning your TV (or VCR) to channel 3, 4, and other inputs. S ENDING D ISCRETE P OWER O N AND O FF Installers use ...

Remote Controls 71 Tips T IPS • If using a specific channel for TV2 (for example, channel 60), TV2’s remote control must be programmed with a TV2 channel/input before you can use RECOVER. • Place the channel sticker on the remote TV and write down the channel you use to watch DISH Network programmin...

Chapter 9 72 Questions Notes 222.book Page 72 Tuesday, July 25, 2006 1:30 PM