Delta LCP-8500A4EDR - Manuals

Page 2 - Preliminary; Absolute Maximum Ratings; Transmitter; Shall be pulled low to

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 2 2008/7/16 Rev. 0A www.deltaww.com Absolute Maximum Ratings Parameter Symbol Min. Typ. Max. Unit Note Storage Temperature T S -40 85 ºC Supply Voltage V CC 0 4 V Relative Humidity RH 5 95 % Recommended Operating Conditions Parameter Symbol Min. Typ....

Page 3 - Optical Characteristics; Link Length; 2 except that the transversal filter differential delay is 33 ps.

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 3 2008/7/16 Rev. 0A www.deltaww.com Optical Characteristics (V CC =3.135V to 3.465V, Data Rate=8.5Gb/sec, PRBS=2 7 -1 NRZ, 50/125 µ m MMF) Parameter Symbol Min. Typ. Max. Unit Note Transmitter Output Optical Power (Avg.) P O -8.2 -1.8 dBm Optical Mod...

Page 4 - SFP+ Transceiver Electrical Pad Layout

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 4 2008/7/16 Rev. 0A www.deltaww.com SFP+ Transceiver Electrical Pad Layout Module Electrical Pin Definition

Page 5 - Pin

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 5 2008/7/16 Rev. 0A www.deltaww.com Pin Logic Symbol Name/Description Note 1 VeeT Module Transmitter Ground 1 2 LVTTL-O TX_Fault Module Transmitter Fault 2 3 LVTTL-I TX_Disable Transmitter Disable; Turns off transmitter laser output 3 4 LVTTL-I/O SDA...

Page 6 - Low speed electrical control pins and 2-wire interface; resistor in the

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 6 2008/7/16 Rev. 0A www.deltaww.com Low speed electrical control pins and 2-wire interface In addition to the 2-wire serial interface, the SFP+ module has the following low speed pins for control and status: ‧ TX_Fault ‧ TX_Disable ‧ RS0/RS1 ‧ MOD_AB...

Page 7 - SerDes IC; Protocol IC; Recommend Circuit Schematic

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 7 2008/7/16 Rev. 0A www.deltaww.com Laser Diode Photo Diode Laser Driver 100 Ohms 0.01uF 0.01uF 0.01uF 0.01uF Preamp & Quanti zer EEPROM 10K Ohms DELTA SFP+ Module 0.1uF 0.1uF 10uF 1uH 1uH 0.1uF 10uF 3 .3 V 100 Ohms* RES1 RES1 VCC SerDes IC RES1 ...

Page 8 - Package Outline Drawing for Metal Housing with Bail de-latch

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 8 2008/7/16 Rev. 0A www.deltaww.com Package Outline Drawing for Metal Housing with Bail de-latch Co m pl ie s wi th 21 CFR 1 040 .1 0 a nd 10 40 .11 Ma de in x FSFS

Page 9 - Timing parameters for SFP+ management; Parameter; not during start up or fault recovery.

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 9 2008/7/16 Rev. 0A www.deltaww.com Timing parameters for SFP+ management Parameter Symbol Min. Max. Unit Note TX_DISABLE Assert time t_off 10 µ sec 1 TX_DISABLE Negate time t_on 2 msec 2 Time to initialize 2-wire interfase t_2w_start_up 300 msec 3 T...

Page 10 - Enhanced Digital Diagnostic Interface; Digital Diagnostic Memory Map Specific Data Field Descriptions

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 10 2008/7/16 Rev. 0A www.deltaww.com Enhanced Digital Diagnostic Interface The memory map in the following describes an extension to the memory map defined in SFP+ MSA. The enhanced interface uses the two wire serial bus address 1010001x (A2h) to pro...

Page 12 - Digital Diagnostic Monitoring Interface; Address

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 12 2008/7/16 Rev. 0A www.deltaww.com Digital Diagnostic Monitoring Interface Alarm and Warning Thresholds (2-Wire Address A2h) Address # Bytes Name Value (Dec.) Unit Note 00-01 2 Temp High Alarm T C (MAX.)+15 02-03 2 Temp Low Alarm T C (MIN.) 04-05 2...

Page 13 - Optional Set of Alarm and Warning; Digital Diagnostic Monitor Accuracy

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 13 2008/7/16 Rev. 0A www.deltaww.com 6) State/ Control Bits Byte Bit Name Description 110 7 Tx Disable State Digital state of the Tx disable input pin 110 6 Soft Tx Disable Read/ Write bit that allow software disable of laser 110 5 Reserved 110 4 Rat...

Page 14 - Regulatory Compliance

LCP-8500A4EDR Preliminary DELTA ELECTRONICS, INC. 14 2008/7/16 Rev. 0A www.deltaww.com Regulatory Compliance Test Item Reference Qty’ Evaluation (#1) Electromagnetic Interference EMC FCC Class B EN 55022 Class B CISPR 22 5 (#2) Immunity ： Radio Frequency Electromagnetic Field EN 61000-4-3 IEC 1000-4...