Delta 23-655 - Manuals

5 ASSEMBLY TOOL RESTS 1. Assemble left tool rest (A) Fig. 3, to left tool rest arm (B), as shown, and fasten with one 5/16-18x3/4" knobhead screw (C) and 5/16" flat washer (D). Assemble theremaining tool rest in the same manner. Do notcompletely tighten hardware at this time. 2. Assemble lef...

6 2. Align the holes in the eye shield with the holes in the spark guard and place the eye shield spacer (A) Fig. 7, inthe space in the spark guard as shown. 3. Insert the eye shield bolt (A) Fig. 8, through the hole in the eye shield (B), eye shield spacer (C), and sparkguard (D). 4. Place a 1/4...

7 EXTENSION CORDS Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug and a 3-holereceptacle which will accept the tool’s plug. When usingan extension cord, be sure to use one heavy enough tocarry the cur...

8 STARTING ANDSTOPPING GRINDER The switch (A) Fig. 14, is located on the front of thegrinder. To turn the grinder “ON” move the switch to the up position. To turn the grinder “OFF” move the switch to the down position. DRESSING AGRINDING WHEEL When dressing a grinding wheel, use a suitable siliconec...

9 CHANGING GRINDINGWHEELS 1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE. 2. When changing wheels, remove the screws attaching the side covers to the grinder and remove theside covers.3. To prevent shaft rotation, place a wedge between the grinding wheel and the tool rest. NOTE: Facing the front of t...