Delta 23-655 - Manual - manualsarea.com

Page 2 - GENERAL SAFETY RULES

2 GENERAL SAFETY RULES Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards involved with the operation of the product. Using the machine with respect and caution willconsiderably lessen the possibility of personal inj...

Page 3 - ADDITIONAL SAFETY RULES FOR GRINDERS

3 ADDITIONAL SAFETY RULES FOR GRINDERS 1. DO NOT OPERATE your tool until it is completely assembled and installed according to the instructions. 2. IF YOU ARE NOT thoroughly familiar with the oper- ation of grinders, obtain advice from your supervisor,instructor or other qualified person. 3. USE onl...

Page 4 - UNPACKING AND CLEANING

4 UNPACKING AND CLEANING Carefully unpack the tool and all loose items from the shipping container(s). Remove the protective coating from allunpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasolineor lacquer thinner for this purpose). Af...

Page 5 - ASSEMBLY; TOOL RESTS; SPARK GUARDS

5 ASSEMBLY TOOL RESTS 1. Assemble left tool rest (A) Fig. 3, to left tool rest arm (B), as shown, and fasten with one 5/16-18x3/4" knobhead screw (C) and 5/16" flat washer (D). Assemble theremaining tool rest in the same manner. Do notcompletely tighten hardware at this time. 2. Assemble lef...

Page 6 - CONNECTING TOOL TO POWER SOURCE; POWER CONNECTIONS

6 2. Align the holes in the eye shield with the holes in the spark guard and place the eye shield spacer (A) Fig. 7, inthe space in the spark guard as shown. 3. Insert the eye shield bolt (A) Fig. 8, through the hole in the eye shield (B), eye shield spacer (C), and sparkguard (D). 4. Place a 1/4...

Page 7 - EXTENSION CORDS; MINIMUM GAUGE EXTENSION CORD

7 EXTENSION CORDS Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug and a 3-holereceptacle which will accept the tool’s plug. When usingan extension cord, be sure to use one heavy enough tocarry the cur...

Page 8 - FLEXIBLE LAMP; GRINDING WHEELS

8 STARTING ANDSTOPPING GRINDER The switch (A) Fig. 14, is located on the front of thegrinder. To turn the grinder “ON” move the switch to the up position. To turn the grinder “OFF” move the switch to the down position. DRESSING AGRINDING WHEEL When dressing a grinding wheel, use a suitable siliconec...

Page 9 - Delta Building Trades and Home Shop Machinery; PARTS, SERVICE OR WARRANTY ASSISTANCE; WRENCH STORAGE

9 CHANGING GRINDINGWHEELS 1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE. 2. When changing wheels, remove the screws attaching the side covers to the grinder and remove theside covers.3. To prevent shaft rotation, place a wedge between the grinding wheel and the tool rest. NOTE: Facing the front of t...

Delta 23-655 - Manual

Table of Contents:

Summary

Other Delta Models