DCS GDE1-30-L - Manuals

5 SAFETY AND WARNINGS ! WARNING! Hot Surface Hazard Failure to follow this advice may result in fire, burns, scalds or personal injury. • Accessible parts may become hot during use.• When in use, do not touch the burner, grate, or immediate surrounding area as these areas become extremely hot. Clean...

6 ! WARNING! Explosion Hazard Failure to follow this advice may result in injury or death • If you smell gas, do not use the appliance. • Do not use water on grease fires, a violent steam explosion may result. Turn all burners off, then smother fire or flame or use dry chemical or foam-type extingui...

7 z Do not store a full LP tank in direct sunlight. z After a period of storage or non-use, the appliance should be checked for gas leaks, deterioration, proper assembly, and burner obstructions before use. General Use z This appliance is not intended to be installed in or on recreational vehicles, ...

8 Gas requirements z This appliance can be used with any brand of 20lb LP gas tank provided it is compatible with a proper retention device (not supplied). z The LP gas cylinder must be: z Designed for use with a Type 1 system only. z Constructed and marked in accordance with the Specifications for ...

9 BEFORE YOU BEGIN z Ensure the installer has completed the final checklist in the installation instructions. z Read this guide, taking special note of the Safety and warnings section. z Remove all packaging and dispose of it responsibly. Recycle items that you can. Seasoning the griddle 1 Clean the...

10 LIGHTING INSTRUCTIONS If burner does not light after several attempts turn the dial to OFF and refer to the troubleshooting section. 2 3 The griddle is equipped with a thermocouple and safety valve system which monitors the burner. This will turn the gas off if the burner isn’t lit. 1 Push in and...

12 2 1 3 Remove the 2 screws securing the valve panel to the unit using a Phillips screwdriver. Remove all dials by pulling outwards. Pull the valve panel down then outward and unplug any wires. Removing the valve panel LEAK TESTING A complete gas tightness check must be performed at the installatio...

14 GRIDDLE PLATE 2 1 3 Remove the vent assembly by pulling up gently from the product, and set aside on a protected surface. Grip the griddle plate from under the brackets at the front and rear of the product as shown. The griddle plate will need to be removed to access the burners for routine clean...

16 BURNER ADJUSTMENT Flames should be blue and stable with no yellow tips, excessive noise or lifting (Note: LP units may have some yellow tipping). If any of these conditions exist, check the air shutter and burner ports are clear. If cleaning these does not improve performance, the air shutter can...

17 CARE AND CLEANING Regulator and hose replacement The pressure regulator and hose assembly supplied with the unit must be used. If replacements are needed, contact customer care at dcsappliances.com. Resetting the flow control Failure to follow the steps in the order shown may cause the Flow Limit...

18 TROUBLESHOOTING PROBLEM POSSIBLE CAUSES WHAT TO DO The griddle won't light when the ignition is pushed There is no gas flowing to the unit. Check gas supply and connections. Ensure no air is trapped in line. There is a something blocking the air or gas flow. Check all openings for blockages. Chec...

19 WARRANTY AND SERVICE Before you call for service or assistance Refer to the installation instructions and your user guide and check that: z Your product is correctly installed. z You are familiar with its normal operation. z Model number (can be found on the inside, right side panel behind the dr...

U S C A 5 9 2 0 67 1 1 .1 9 DCSAPPLIANCES.COM © Fisher & Paykel Appliances 2019. All rights reserved. The product specifications in this document apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may...