Cisco WS-X4516 - Manuals

10 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Supervisor Engine V Gigabit Ethernet Uplink Ports The Gigabit Ethernet uplink ports operate in full-duplex mode only. These ports use the 1000BASE-T, 1000BASE-SX, 1000BASE-LX/LH, 1000BASE-ZX, CWDM, an...

11 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Port Cabling Specifications Flash Port The Flash port accepts a Type 1 compact Flash card. You can use it for file transfer tasks such as loading a new software image. The Flash card is optional and c...

12 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Port Cabling Specifications Table 4 provides cabling specifications for the GBICs that you install in the Gigabit Ethernet port modules. All GBIC ports have SC-type connectors, and the minimum cable d...

13 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Installing and Removing the Supervisor Engine Installing and Removing the Supervisor Engine All Catalyst 4500 series switches support hot swapping, which lets you install, remove, replace, and rearran...

14 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Installing and Removing the Supervisor Engine • When installing a component, use any available ejector levers or captive installation screws to properly seat the bus connectors in the backplane or mid...

15 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Installing and Removing the Supervisor Engine Step 6 Align the edges of the supervisor engine carrier with the slot guides on the sides of the switch chassis, as shown in Figure 2 . Figure 2 Installin...

16 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Installing and Removing the Supervisor Engine Removing the Supervisor Engine Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or view di...

17 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Attaching Module Interface Cables Warning Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages and currents inside the chassis; they contain e...

18 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Configuring Your Supervisor Engine Figure 5 SC-Type Fiber-Optic Connector Configuring Your Supervisor Engine For information and commands to configure your supervisor engine, refer to the Software Con...

19 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 GBIC Handling Guidelines and Installation Caution Because of interoperability issues, Cisco does not support GBICs purchased from third-party vendors. Cisco 1000BASE-LX/LH interfaces fully comply with...

20 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 GBIC Handling Guidelines and Installation Figure 7 Installing a GBIC Step 4 Slide the GBIC into the slot until you hear a click. The click indicates that the GBIC is locked into the slot. Step 5 When ...

21 Installation and Configuration Note for the Catalyst 4500 Series Supervisor Engine V 78-15590-02 Related Documentation GBIC Maintenance Guidelines To properly maintain GBICs, follow these guidelines: • GBICs are sensitive to static. To prevent ESD damage, follow normal handling procedures. • GBIC...