Cisco 8110 - Manuals - manualsarea.com

Page 2 - Basic Hardware Features; Power Supply and Fuses; Cable Connections; Connecting Optical Cables

3-2 Cisco 8110 Broadband Network Termination Unit User Guide 78-11666-01 Chapter 3 Installation Basic Hardware Features Basic Hardware Features The unit can be fitted into a standard 19” rack or as a desktop and is 2.6” (1.5U high). For rackmounting, the unit is simply screwed to the sides of the ra...

Page 3 - Connecting Electrical Signal Cables; Connecting the Terminal

3-3 Cisco 8110 Broadband Network Termination Unit User Guide 78-11666-01 Chapter 3 Installation Basic Hardware Features Step 3 Snap the other end of the cable into the ATM switch or other ATM equipment. Be sure that each cableconnects to Tx on one end and Rx on the other. Connecting Electrical Signa...

Page 4 - CIT Pinout; LIM Modules; Installing a Line Interface / Compact Subscriber Module (LIM)

3-4 Cisco 8110 Broadband Network Termination Unit User Guide 78-11666-01 Chapter 3 Installation Basic Hardware Features CIT Pinout Table 3-1 shows the serial port pinout configuration. LIM Modules Caution The T1/E1 and T3/E3 connections are restricted to intra-building use only. Do not connectto exp...

Page 5 - Replacing Modules; Connecting the External Timing

3-5 Cisco 8110 Broadband Network Termination Unit User Guide 78-11666-01 Chapter 3 Installation Basic Hardware Features Removing a Line Interface / Compact Subscriber Module (LIM) To remove a LIM in your Cisco 8110: Step 1 Change the module state to OOS (Out of Service) using the console, or the in-...

Page 6 - Connecting the External alarms

3-6 Cisco 8110 Broadband Network Termination Unit User Guide 78-11666-01 Chapter 3 Installation Basic Hardware Features Step 4 Attach the other end of the cable connected to the IN connector, to the timing source. Step 5 If required, attach the other cable into the ETS OUT port on rear panel of the ...

Page 7 - Alarms Pinout; Removable Power Supply; Unpacking the Power Supply

3-7 Cisco 8110 Broadband Network Termination Unit User Guide 78-11666-01 Chapter 3 Installation Removable Power Supply Alarms Pinout Table 3-2 shows alarm pinout configuration Removable Power Supply This section contains the following topics: • Unpacking the Power Supply • Basic Hardware Features • ...

Page 9 - Power Supply Installation; Installing a Power Supply

3-9 Cisco 8110 Broadband Network Termination Unit User Guide 78-11666-01 Chapter 3 Installation Removable Power Supply Connecting 8110-PS-DC To connect your 8110-PS-DC DC Power Supply: Step 1 Connect a minimum 14AWG ground wire to the stud located on the rear of the chassis. Fasten with alockwasher ...

Page 10 - Removing a Power Supply; Power Supply LEDs; General Operating Procedures

3-10 Cisco 8110 Broadband Network Termination Unit User Guide 78-11666-01 Chapter 3 Installation General Operating Procedures Removing a Power Supply To remove a power supply from your Cisco 8110: Step 1 Change the module state to Out Of Service (OOS) using the console, or the in band managementappl...