Bromic BH0320007 - Manuals - manualsarea.com

Page 2 - IMPORTANT

2 bromic.com/heating Head Office: 10 Phiney Place, Ingleburn, NSW 2565 Australia Telephone: 1300 276 642 (within Australia) or +61 2 9748 3900 (from overseas) Fax: +61 2 9748 4289 Email: [email protected] Web: www.bromic.com/heating ! IMPORTANT This manual contains important information about the in...

Page 3 - CONTENTS

3 bromic.com/heating CONTENTS IMPORTANT NOTES & WARNINGS 4 PRODUCT OVERVIEW 5 PRODUCT DESCRIPTION 5 SPECIFICATIONS 5 PRODUCT FEATURES 5 HEATER INSTALLATION INSTRUCTIONS 6 CEILING & WALL MOUNTING 6 CEILING RECESS 9 TUBE SUSPENSION 10 ELECTRICAL INSTALLATION 11 SERVICING 11 TROUBLESHOOTING 11

Page 4 - IMPORTANT NOTES AND WARNINGS

4 bromic.com/heating IMPORTANT NOTES AND WARNINGS WARNING IMPORTANT - Installation MUST be carried out by a licensed and authorised person. • Improper installation, adjustment, or alteration and Failure tofollow the warnings and instructions in this manual could resultin severe personal injury, deat...

Page 5 - PRODUCT OVERVIEW; CONTINUED; PRODUCT FEATURES

5 bromic.com/heating service technician if you are unsure if you have a circuit breaker installed on the premises. • Do not install the heater directly near a bathtub, shower orswimming pool. Any switches or controls must not be withinreach of a person in the bathtub, shower or swimming pool. • To m...

Page 6 - HEATING INSTALLATION INSTRUCTIONS; WARNING - Outdoor Installation; CEILING & WALL MOUNTING

6 bromic.com/heating HEATING INSTALLATION INSTRUCTIONS PRODUCT FEATURES This heater MUST be permanently installed by an authorised/licenced person. Do not perform maintenance, or carry out installation or assembly procedure while electrical power is switched on. Wait 2 hours after switching off the ...

Page 7 - Wall mount

7 bromic.com/heating HEATING INSTALLATION INSTRUCTIONS CONTINUED... OPTION 1 To exit the cable through the side of the wall mounting bracket, start from step 1. 1. Unscrew and remove plug-in wall bracket (a) . 2. Attach extra supplied cable gland into the samehole from the outside of the bracket. Fa...

Page 8 - Straight bracket option

8 bromic.com/heating HEATING INSTALLATION INSTRUCTIONS CONTINUED... 8. To fix heater at desired angle, fully insert M3x0.4” positioning screws (included with wall bracket) onboth sides of mounting bracket whilst holding heater in the desired position (h). The heater can positioned straight, or be an...

Page 9 - CLEARANCE TO COMBUSTIBLES OPTION 1

9 bromic.com/heating HEATING INSTALLATION INSTRUCTIONS CONTINUED... CEILING RECESS (SOLD SEPARATELY) WARNING Instructions below are suitable for ceiling surfaces 0.4-1.2” thick. For ceiling surfaces thicker than 1.2” , contact Bromic for alternative installation options. ! ! WARNING The heater shall...

Page 11 - TUBE SUSPENSION

11 bromic.com/heating HEATING INSTALLATION INSTRUCTIONS CONTINUED... HEATING INSTALLATION INSTRUCTIONS CONTINUED... 11. Attach the bracket end-cap to the wall bracket using the4 M5 screws and nuts provided (k). 12. Carefully remove the 4 M5 screws fastening the heatermounting bracket to the back of ...

Page 12 - ELECTRICAL INSTALLATION; MAINTENANCE; SERVICING; SYMPTOM; No heat; TROUBLESHOOTING

12 bromic.com/heating ELECTRICAL INSTALLATION This heater MUST be permanently installed by an authorised/licenced person. Do not perform maintenance, or carry out installation or assembly procedure while electrical power is switched on. To disconnect heater, turn off power to heater circuit at main ...