Bostitch T55 - Manuals - manualsarea.com

Page 2 - FASTENERS

INTRODUCTION The Stanley-Bostitch T55 series staplers are precision-built tools, designed for high speed, high volume stapling. These toolswill deliver efficient, dependable service when used correctly and with care. As with any fine power tool, for best performance the manufacturer’s instructions m...

Page 4 - T55 TOOL SPECIFICATIONS; FASTENER SPECIFICATIONS:; OPERATION; CONTACT TRIP

-4- T55 TOOL SPECIFICATIONS All screws and nuts are metric. FASTENER SPECIFICATIONS: TOOL AIR FITTING: This tool uses a free-flow connector plug, 1/4” N.P.T. The minimum inside diameter should be .200” (5mm). The fitting must be capable of discharging tool air pressure when disconnected from the air...

Page 5 - AIR SUPPLY AND CONNECTIONS; LUBRICATION; COLD WEATHER OPERATION:

-5- AIR SUPPLY AND CONNECTIONS Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool may explode, possibly causing injury. FITTINGS: Install a male plug on the tool which is free flowing and which will release air pressure from the tool when disconnected from...

Page 6 - LOADING THE T55; ” FASTENER CONTROL ADJUSTMENT

-6- EYE PROTECTION which conforms to ANSI specifications and provides protection against flyingparticles both from the FRONT and SIDE should ALWAYS be worn by the operator and others in the workarea when loading, operating or servicing this tool. Eye protection is required to guard against flyingfas...

Page 7 - TOOL OPERATION

-7- EYE PROTECTION which conforms to ANSI specifications and provides protectionagainst flying particles both from the FRONT and SIDE should ALWAYS be worn by theoperator and others in the work area when loading, operating or servicing this tool. Eyeprotection is required to guard against flying fas...

Page 8 - TOOL OPERATION CHECK

-8- TOOL OPERATION CHECK CAUTION: Remove all fasteners from tool before performing tool operation check. 1.TRIGGER OPERATED TOOL: A. With finger off the trigger, hold the tool with a firm grip on the handle. B. Place the nose of the tool against the work surface. C. Pull the trigger to drive. Releas...

Page 9 - ASSEMBLY PROCEDURE FOR SEALS:

-9- BASIC TOOL OPERATION Stanley-Bostitch pneumatic tools are cycled by a compressed air operated single piston design. The following illustrations show the four functional cycles that occur when the tool is operated to drive a fastener: MAINTAINING THE PNEUMATIC TOOL When working on air tools, note...

Page 10 - TROUBLE SHOOTING; PROBLEM

-10- TROUBLE SHOOTING PROBLEM CAUSE CORRECTION Trigger valve housing leaks air O-ring cut or cracked Replace O-ring Trigger valve stem leaks air O-ring/seals cut or cracked Replace trigger valve assembly Frame/nose leaks air Loose nose screws Tighten and recheck O-ring or Gasket is cut or cracked Re...

Page 11 - QUICK RELEASE DOOR

DIRECTIONAL EXHAUST DEFLECTOR Loosen screw as shown. Adjust to desired exhaust direction and tighten screw. -11- ACCESSORIES AVAILABLE BC601 4 oz. Stanley-Bostitch Air -Tool Lubricant BC602 1 pint Stanley-Bostitch Air -Tool Lubricant BC603 1 pint Stanley-Bostitch “Winter-Fromula” Air-Tool Lubricant ...