Blodgett SC-10E - Manuals - manualsarea.com

Page 4 - SERVICE CONNECTIONS

Page 5 - floor. Seal bolts and flanged feet with Silastic.

5 2.0 INSTALLATION INSTRUCTIONS This steamer was inspected before leaving the factory. The transportation companyassumes full responsibility for safe delivery upon acceptance of the shipment.Immediately after unpacking the steamer, check for possible damage. If the steamer isfound to be damaged afte...

Page 7 - Mineral scale on components causes several problems:

7 DRAIN CONNECTIONS The drain connection must be 1" (25 mm)IPS down, preferably with one or twoelbows only, maximum length 6 feet (1830mm) and piped to an open gap type drain(Figure 1). Drain pipe should be either ironor copper. DO NOT use PVC pipe – PVCpipe may lose its rigidity or glue may fai...

Page 8 - VENT HOOD; Vapor Removal from Cooking Equipment

8 VENT HOOD Some local codes may require the steamer to be located under an exhaust hood.Information on the construction and installation of ventilating hoods may be obtainedfrom NFPA Standard No. 96, Vapor Removal from Cooking Equipment , (latest edition). START-UP TEST WARNING: The steamer and its...

Page 13 - WARNING: DO NOT use cleaning agents that are corrosive.; Turn main power switch OFF.; CAUTION: Do not allow

13 4.0 CLEANING WARNING: DO NOT use cleaning agents that are corrosive. WARNING: Disconnect the power supply to the appliance beforecleaning or servicing. At the end of each day, or between cooking cycles if necessary... Turn main power switch OFF. Remove pans and racks from compartment and wash in ...

Page 14 - GUIDELINES FOR MAINTAINING STAINLESS STEEL SURFACES; rinse repeatedly

14 GUIDELINES FOR MAINTAINING STAINLESS STEEL SURFACES There are three things that can break down stainless steel and allow corrosion todevelop: 1) Abrasion; 2) Deposits and water; 3) Chlorides. Avoid rubbing with steel pads, wire brushes, or scrapers that can leave iron deposits onstainless steel; ...

Page 15 - REMOVAL OF SCALE DEPOSITS; allow generator to drain.

15 5.0 MAINTENANCE REMOVAL OF SCALE DEPOSITS WARNING: Read and follow instructions on the CLR bottle. Useplastic or rubber gloves to avoid skin contact. IF CLR comes incontact with skin, rinse and clear water. 1. Drain steam generator tank by setting ON/OFF switch to off. Set cooking timer to “OFF”....

Page 16 - Short between probe terminal and

16 6.0 TROUBLESHOOTING PROBLEM POSSIBLE CAUSES Cold water flows continuously into drainwhen steamer is OFF. Either or both solenoid valves are notclosing. Contact your authorized serviceagency to repair or replace solenoidvalves. Water overflowing into cookingcompartment. Problem with operating prob...

Page 17 - Remove side panel and turn control panel power switch to ON.; WATER FLOWS INTO DRAIN DURING SHUTDOWN; diaphragm or core tube.

17 7.0 SERVICE ADJUSTMENT FOR HIGH ALTITUDE LOCATIONS NOTICE: Contact the factory, the factory representative or local servicecompany to perform maintenance and repairs. The steamer has been factory set so that when it is ON and during the READY phase, itwill maintain water temperature in the steam ...

Page 18 - WATER OVERFLOWS INTO COOKING COMPARTMENT; READY light does not come on after about 15 minutes,; HEATER ELEMENTS DO NOT COME ON

18 8.0 SERVICE (Continued) WATER OVERFLOWS INTO COOKING COMPARTMENT When steamer is first turned on for the day, and the following conditions occur: - READY light does not come on after about 15 minutes, - Water begins to overflow into cooking compartment, - Water fill solenoid valve is open, then a...