Billion BIPAC-2AB 2.0 - Manuals

Page 3 - Table of Contents; CHAPTER 1

Table of Contents CHAPTER 1 1 Introduction ................................................................................... 1 An Overview of the BIPAC-2AB 2.0 .......................................... 1 Package Contents ......................................................................... 2 ...

Page 5 - Chapter 1; Introduction

Chapter 1 Introduction An Overview of the BIPAC-2AB 2.0 What is ISDN? ISDN is an abbreviation for I ntegrated S ervices D igital N etwork. ISDN transfers information digitally and integrates all telecommunication services (such as telephone, teletext, videotex, etc.) into a single network. Using ISD...

Page 6 - Package Contents

BIPAC-2AB 2.0 User’s Manual 2 The BIPAC-2AB 2.0 ISDN a/b Adaptor The BIPAC-2AB 2.0 ISDN a/b adaptor allows you to make the transition from analog to digital without having to discard all your present analog devices. The BIPAC-2AB 2.0 provides an interface between your ISDN line and present analog de...

Page 7 - Chapter 1 Introduction

Chapter 1 Introduction 3 2. One RJ-45 cable 3. One AC-to-DC power adaptor 4. This User’s Manual BIPAC-2AB 2.0 Features The BIPAC-2AB 2.0 supports many standard and enhanced features that allow you to make full use of ISDN services with your existing analog devices, including the following: Caller ID...

Page 8 - Chapter 2; Before Connecting

Chapter 2 Using BIPAC-2AB 2.0 Before Connecting Make sure that you have all you need to connect the BIPAC-2AB 2.0 ISDN a/b adaptor. You should have the following: 1. At least one analog telephone (or other analog device) 2. A power outlet that supplies 220 ~ 240 volts AC 3. An ISDN basic rate S 0 in...

Page 9 - The Front Panel LEDs

Chapter 2 Using BIPAC-2AB 2.0 5 F IGURE 2: C ONNECTING THE BIPAC-2AB 2.0 4. The BIPAC-2AB 2.0 ISDN a/b adaptor will run a Power-On self- diagnostic test. The LEDs on the front panel will blink on and off one by one and the connected analog telephones will ring. The Front Panel LEDs The following ill...

Page 12 - Using the Telephone Functions

BIPAC-2AB 2.0 User’s Manual 8 Ring Pattern (Alert On/Off Length) Setup * 83 * Pass * Func Id * Parameter # Func Id=0, Ring unit parameter=01~99(0.1s) Default is 10 (1s) Func Id=5, Hold Notice Parameter=00~99 Ring unit Default is 0 Func Id=1~3, MSN1~3 Func Id=4, Default Ring Pattern Func Id=6, Intern...

Page 16 - Chapter 3; Troubleshooting; Troubleshooting Procedures

Chapter 3 Troubleshooting Troubleshooting Procedures Error Event Possible Cause Remedy The B1 LED is always lit after power up The RAM is defective. Consult your dealer. The B2 LED is always lit after power up The ISDN chip is defective. Consult your dealer. No dial tone from ISDN switch or PABX 1. ...

Page 17 - Appendix A — Product Support

Appendix A — Product Support 13 Error Event Possible Cause Remedy Can not receive incoming call. 1. Incoming call’s phone number does not match any a/b port’s phone number 1. Ensure that the phone number for each a/b port is correctly configured. 2. Do Not Disturb function has been enabled. 2. Disab...