Belkin RVMPKG2 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS

2 TABLE OF CONTENTS Caut ions! ............................................................................................ 3 Preface ............................................................................................... 4 WARNING: ..............................................................

Page 4 - Preface; Backing up vehicle; Packing list

4 Preface There is a blind spot that exists at the back of a vehicle while the vehicle is in reverse. Equipped with a camera, this rearview mirror/monitor ensures safety by providing the driver with a clear and wide image of the area behind the vehicle while it is in reverse. WARNING: Backing up veh...

Page 5 - Installation Instructions; igure 2

5 1. Installation Instructions (1) Mount the mirror/monitor onto the existing rearview mirror. a) Stick two adhesive foam backings on to the back of mir ror in the two small rectangle indents. b) Take the two seven inch belts and slide them into the slots on the top rear of the mirror with grooved s...

Page 6 - Install the mobile phone hands free seat

6 Figure 3 e) Cut off the excess part of the 7-inch strap (2) Plug the Mitsumi connector from the Audiovox navigation monitor cable (part #112C3080) into the receptacle at the top backside of the mirror/monitor screen. Route the rest of the monitor cable to the Navigation computer. (3) Connect the c...

Page 7 - Figure 4

7 (2) Tear off the adhesive tape on the back of the hands free seat. Press tightly to seat on to the selected surface for 30 seconds till the two surfaces are tightly glued. NOTE: Make sure the two surfaces are glued tightly! (3) Clean a place on the back of the cell phone, keeping it dry. Remove th...

Page 8 - only

8 3. Signal Inputs The signal input connections for the system include: (1) Rear Camera: By connecting rear camera with control box plug, users can see the rearview when the vehicle is in reverse. (2) Hands Free Jack: Put the hands free plug (3.5mm) into hands free jack and put the other side of plu...

Page 9 - Controls and Indicators

9 Figure 5 Figure 6 4. Controls and Indicators Figure 6 illustrates the controls and indicators of the RVMPKG2 rear view mirror: A : Rearview mirror B : 4” LCD panel C : Hands free Microphone D : Brightness Control E : Power indicator (Red when ignition is on) F: Volume Control G: Switch 1 (see belo...

Page 10 - Vehicle Reversing

10 L : Infra- RED receiver for M : 3-position switch for Navigation Navigation remote control voice command display timer on rear of mirror (30 sec., 150 sec., 300 sec.) N: 2-position switch for hands free microphone sensitivity High/Low select SW1, SW2 and SW 3: 1. Vehicle Reversing : SW 1: No func...

Page 12 - Specifications

12 Specifications General Power Supply 12VDC Power Consumption <12W Current Draw <500 mA Video Input 1Vp -p@ 75 Impedance Audio Input <=1V Audio Power Output 0.5W × 2 (16O) Operating Temperature -10 ° C to 60 ° C Overall Dimension 11W × 3.75H × 1.25D inch Display System Screen 4 ” TFT Color...

Page 13 - Troubleshooting; Table 1 Rearview Mirror

13 Maintenance Maintenance Your rearview mirror requires little care, however to maintain it in optimum condition follow the procedures below: 1. Keep your system away from excessive moisture, extreme heat or cold and magnetic fields. 2. Keep liquids away from the display. 3. Do not place external d...

Page 14 - Table 2 Hands Free Phone; Symptoms; Check the volume control knob

14 Table 2 Hands Free Phone Symptoms Solutions When the Hands Free Phone Function is not working? 1. Check the volume control knob whether the volume is set too low. 2. Check to see if the hands free cable plug to the phone hand set input jacket is properly connected. 3. Check whether the mobile pho...