Avalon B3BLOZONEWTRCLR - Manuals

2 Part Names 8. Cold Water Push Button 14. Drip Tray 9. Panel 7. Room Temperature Water Push Button 5. Hot Water Push Button 6. Child Safety Lock 1. Power/Self-Cleaning Indicator Light 3. Cooling Indicator Light 4. Empty Bottle Indicator Light 2. Heating Indicator Light 11. Room Temp Spout 10. Hot W...

4 Indicator Lights Power/Self-Cleaning Indicator Light This light will remain steady on to indicate that the unit is plugged in and the power is on. When the unit is placed into self-cleaning mode this indicator light will blink until the cycle is complete. When the cycle is complete the light will ...

5 Tech Specs Model A3BLOZONEWTRCLR Hot/Cold/Room Temp Output Hot Water Capacity Hot Tank Volume Cold Water Capacity Cold Tank Volume Product Size Packing Size Net Weight/Gross Weight Voltage/Frequency Cooling Method Heating Method Heating Watts / Cooling Watts Power Consumption 1.2L/min / 1.2L/min /...

7 Unpacking your Avalon Water Cooler The unit has been cleaned prior to departing from the factory. To remove any dust and debris that may collect during shipping we recommend cleaning the unit prior to installation. For cleaning instructions, see pages 17-21. Do NOT plug in the power cord yet.Place...

8 Installing the Water Bottle 1. Open the cabinet door. 3. Place a fresh bottle outside of the cabinet. 2. Place the probe assembly on the probe hanger. 4. Remove the entire plastic cap from the top of the bottle. 5. Clean the outside of the new bottle with a cloth. Getting Started

10 Installing and Removing the Drip Tray 1. To install the drip tray, simply slide it into the area at the top of the door until it snaps into place. 2. To remove the drip tray, place your fingers in the grid of the drip tray with one hand and hold the door of the cooler shut with the other. 3. Gent...

11 Powering the Dispenser Plug cord into a properly grounded wall outlet. At this time the pump will begin to move water from the bottle to the hot and cold tanks. It will take up to 12 minutes to fill the tanks for the first time. During this period the pump will run continuously. This is normal. G...

12 Activate Heating and Cooling To activate the cold water, push the cooling switch (#17) into the on (I) position by pushing the top of the switch in. If you do not wish to have cold water you can leave the switch in the off (O) positon.To activate the hot water, push the heating switch (#18) into ...

14 Dispensing Water Cold Water Hot Water Room Temperature Water Once you have turned the cooling switch (#17) into the on (I) position it will take initially 1 hour for the water to cool. During this time the cooling indicator light (#3) above the cold water icon will be steady. During this time the...

15 Changing the Bottle When the empty bottle indicator light (#4) is flashing red this is an alert that your bottle is empty and will need to be replaced as soon as possible.Notice: Do not dispense hot, room temperature or cold water if the light is flashing as you could empty the tanks and cause th...

18 Activating Self-Cleaning Function 3. Ozone will be produced and injected into the water system, it will kill bacteria and bio-films typically found in water dispensers. By the end of the cleaning cycle the ozone will convert into harmless oxygen and will be emitted into the air. 1. To activate, p...