Avalon A12BLK - User Manual

Page 2 - Use and Care Guide

Use and Care Guide MODELS: A12-CTPOU Registration Please visit the website below to register your new water cooler within the first 30 days of purchase. Registration within the first 30 days will activate your one year warranty. www.avalonh2o.com/register-my-avalon-cooler Please keep your model numb...

Page 3 - Contents

Contents About Your Water Cooler Meet Your Avalon Product Part Names Indicator Lights Tech Specs Filter Function Introduction Getting Started Unpacking Installation (Under the Sink) Installation (Refrigerator Water Line) Flushing Filters Finishing Water Cooler Installation Activating Heating and Coo...

Page 5 - Meet Your Avalon Product

1 Meet Your Avalon Product Inside the box, you’ll find: About Your Water Cooler Adapter with Valve 2 Small PE Tubing 2 Mounting Brackets Carbon Block Filter Sediment Filter Three Way Plastic Adapter 2 Filter Adapters Valve and Tube Assembly PE Tubing (20')

Page 7 - Part Names

3 9. Panel 11. Room Temp Spout 10. Hot Water Spout 6. Child Safety Lock 13. Nightlight 12. Cold Water Spout 14. Drip Tray 8. Cold Water Push Button 7. Room Temperature Water Push Button 5. Hot Water Push Button 2. Heating Indicator Light 3. Cooling Indicator Light 4. Filter Indicator Light 1. Power/...

Page 9 - Indicator Lights

5 Indicator Lights Power/Self-Cleaning Indicator Light This light will remain steady on to indicate that the unit is plugged in and the power is on. When the unit is placed into self-cleaning mode this indicator light will blink until the cycle is complete. When the cycle is complete the light will ...

Page 10 - Tech Specs

6 Tech Specs 1.2L/min / 1.2L/min / 1.0L/min 4 L/H (≥ 185°F) 1.16 Liters 2.5 L/H ( ≤ 50°F) 3.6 Liters 0.1-0.4 MPa Tap Water Sediment Carbon Block 13”(L)x12”(W)x41”(H) 16”(L)x15”(W)x45”(H) 27.78 lb/37.48 lb 115V 60Hz Compressor Internal Element 420W/100W 520W Hot/Cold/Room Temp Output Hot Water Capaci...

Page 11 - Filter Function Introduction

7 Filter Function Introduction Stage Stage 1 Stage 2 Sediment Filter Carbon Block Filter Filter Course filtration of raw water to remove rust, dirt and sediment Removes the water odor, residual chlorine, organic matter, and lead to improve taste Function About Your Water Cooler

Page 12 - G e t t i n g Sta r te d

Page 13 - Unpacking Your Avalon Water Cooler

9 Unpacking Your Avalon Water Cooler Locating Dispenser • Do NOT plug in the power cord yet. • Place dispenser upright on a hard and level surface in a cool and shaded location near a grounded wall outlet. Position the dispenser so there is about 4 inches of clearance from the wall on the back and b...

Page 17 - Flushing Filters Prior to Use

13 Flushing Filters Prior to Use Before continuing with installation, it is recommended that you flush both filters for approximately 2 minutes. 1. Twist the filter into the provided Filter Flushing Adapter by rotating it clockwise. 3. Hold the filter with the Filter Flushing Adapter in place over a...

Page 19 - Finishing the Water Cooler Installation

15 Getting Started Finishing the Water Cooler Installation Once you have flushed the filters and removed the filters and PE Tubing from the Filter Flushing Adaptor, you are ready to complete the installation process. 1. Locate the two black Mounting Brackets. Clip each bracket, one next to the other...

Page 23 - Activate Heating and Cooling

19 Activate Heating and Cooling To activate the cold water, push the cooling switch (#20) into the on (I) position by pushing the top of the switch in. If you do not wish to have cold water you can leave the switch in the off (O) positon.To activate the hot water, push the heating switch (#21) into ...

Page 24 - Installing and Removing the Drip Tray

20 Installing and Removing the Drip Tray 1. To install the drip tray, simply slide it into the area below the spouts until it snaps into place. 2. To remove the drip tray, place your fingers in the grid of thte drip tray with one hand and hold the cooler of the cooler shut with the other. 3. Gently ...

Page 25 - Us e r G u i d e a n d Ma i n te n a n c e

Page 26 - Dispensing Water

22 Dispensing Water Cold Water Hot Water Room Temperature Water Once you have turned the cooling switch (#20) into the on (I) position it will take initially 1 hour for the water to cool. During this time the cooling indicator light (#3) above the cold water icon will be steady. During this time the...

Page 27 - Replacing the Filters

23 Replacing the Filters 1. When lifetime of the filter is near its end, either by means of water flow or by means of 6 months time, the filter indicator light (#4) on the right side of the front panel will blink red as a warning. When the filter lifetime is up, the indicator light will be steady re...

Page 30 - Leak Detection

26 Leak Detection Our machines are equipped with a high-tech leak detector that will alert you of any potential leak. At the same time the machine will automatically shut off any intake of water to prevent a potential flood. In the event of a possible leak, the heating indicator light (#2), cooling ...

Page 31 - C l e a n i n g

Page 32 - Activating Self-Cleaning Function

28 Activating Self-Cleaning Function 3. Ozone will be produced and injected into the water system, it will kill bacteria and bio-films typically found in water dispensers. By the end of the cleaning cycle the ozone will convert into harmless oxygen and will be emitted into the air. 1. To activate, p...

Page 38 - Tro u b l e s h o ot i n g

Page 41 - S a fe t y