Audiovox XR9000 - Manuals - manualsarea.com

Page 2 - YOUR “CODE HOPPING“ TRANSMITTERS; system

128-7863 2 of 20 Page 2 Additional Engine Immobilizer Output, (Optional Relay Required)True Last Door Arming (Hardwire Only)Defective Zone By-PassDefective Zone Chirp Confirmation (Unit Chirps To Report Zone Cleared)6 Tone Mini SirenCar Horn Output For Additional Alarm Response (Improved Timing To M...

Page 4 - PROTECTION WHILE THE SYSTEM IS ARMED

128-7863 4 of 20 Page 4 Doors Lock - Optional NOTE: If the optional Headlamp illumination feature has been added, and has been selected for operation when arming, as an added convenience, the sys-tem will turn on the headlights when the system is armed.The LCD Remote has the following response: ARMI...

Page 5 - SILENT DISARMING

128-7863 5 of 20 Page 5 transmitter button is activated, the drivers door only will unlock, pressing theunlock button a second time will cause all doors to unlock. NOTE: If your transmitter has been configured with single button Lock/Unlock, to activate the all door unlock feature operate the Lock/U...

Page 9 - RF SHOCK SENSOR MODE SELECTION

128-7863 9 of 20 Page 9 again for 3 seconds. If the button is not pressed, the alarm will automatically stop after 30 seconds. Also if any transmitter button other than the Lock or Unlock button is pressed and released, the Panic mode will be turned off immediately. The normal function of this trans...

Page 10 - To Remote Start The Vehicle:

128-7863 10 of 20 Page 10 programmed, simply press the lock button of your keychain transmitter anytime during the remote start cycle. The shock sensor will be shunted for the entire run cycle and will resume normal operation after the remote start unit shuts off.Check with your installation center ...

Page 12 - TURBO TIMER MODE

128-7863 12 of 20 Page 12 NOTE: The feature that has been added to channel 3 will always be activated using the same transmitter button that remotely starts the vehicle. There is no way to move the channel 3 function to a different transmitter button. ADDITIONAL REMOTE FUNCTION (CHANNEL 4) This syst...

Page 13 - TRANSCEIVER ICONS AND THEIR INDICATIONS

128-7863 13 of 20 Page 13 1) Place the gear selector in park. 2) Set the parking, (hand), brake. 3) Be certain your foot is off the brake pedal. 4) Press the program/Push-Button switch 2 times within 5 seconds. The parking lights will flash two times indicating the mode was successfully en- tered. I...

Page 14 - ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:

128-7863 14 of 20 Page 14 When the Panic Mode has been activated and the system is armed the vehicle's lights will flash, the siren and lock icon will be displayed on the LCD screen and the siren will beep. If the system is disarmed and the Panic Mode is activated, the lights will flash unlock icon ...

Page 17 - Parking Meter Counter:

128-7863 17 of 20 Page 17 activated at the vehicle, you can toggle the feature on simultaneously pressing the Lock + Option buttons of the transmitter. The 24 hour icon will appear and the transmitter will emit a tone confirming the feature is active. Note: the unit will start once and run for the p...

Page 18 - Temperature Start Mode.

128-7863 18 of 20 Page 18 Battery Indicator: Your transmitter has a battery indicator that is shown in the upper rightcorner of the screen as shown left. This icon indicates a new battery shown with 3 bars. As the battery deteriorates, the bars will disap- pear. 1 bar indicates the battery should be...

Page 20 - SYSTEM FUNCTIONS AT A GLANCE; DASH LED INDICATORS

128-7863 20 of 20 Page 20 XR9000 SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING/ACTIVE REARMINGSLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 3 FLASH...PAUSE = INTRUSION ZONE 3 2 FLASH...PAUSE = INTRUSION ZONE 2 1 FLASH...PAUSE = INTRUSION ZONE 1 SIREN C...