Audiovox VOH701 - Manuals - manualsarea.com

Page 2 - Important Notice; It is unlawful in most jurisdictions for a person

Important Notice It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that islocated in the motor vehicle at any point forward of the back of the driver's seat, or that is visible directly or indirectly to the operator of the...

Page 3 - MATERIALS INCLUDED IN THIS PACKAGE:; ) Hardware Package

MATERIALS INCLUDED IN THIS PACKAGE: 1) VOH701 Video Monitor (1 pc)2) Accessory Harness (P/N 8010730) (1 pc)3) 2 Pin Power Wire Harness with choke (P/N 112B2824) (1 pc)4) A/V Adapter Cable (112B3227) 5) Hardware Package #4 x 3/8” Screws (5 pcs)#8 x 5/8” Self Drilling Screws (4 pcs)#8 Washers (4 pcs) ...

Page 4 - GENERAL INSTALLATION APPROACH:; their respective locations.; GENERAL SYSTEM CONFIGURATIONS:

GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Tuner, RF Modulator/external amp, remote headphones, 2 nd VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups.3) Decide upon m...

Page 5 - FULL SIZE CONSOLE INSTALLATION

VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v whenkey is off). Find a suitable location that will provide a good ground. Generally, these wires can befound at the ignition switch or fuse-box. 2) The mounting method and location will ...

Page 6 - MINI CONSOLE INSTALLATION:; Lowest point mark

MINI CONSOLE INSTALLATION: This page only covers special installation considerations for the mini-console installation. If the videomonitor is to be installed with a custom full sized overhead console, refer to page 3.If the video monitor is to be installed in a vehicle with the mini console (P/N 11...

Page 7 - MOUNTING THE MINI-CONSOLE

Roof Roof Support Headliner 5"x9"x3/4" PlywoodBlock or OptionalVOHBKT (4) #8x1" self drilling screws (not supplied) Mini-Console Video Unit (4) #8 flat washers (not supplied) (4) #8x3/4" self tapping screws (not supplied) -5- MOUNTING THE MINI-CONSOLE

Page 8 - Note

1) Make the connections to the vehicle for the 2 pin wiring harness.2) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB. 3) Pull the wire tie loop tight and cut off the excess.4) Connect t...

Page 9 - Positive Switched Dome lighting; CONNECTING THE DOME LIGHTS

-7- Red / black - Lamp on Black / red - Lamp common Purple / brown - Lamp Auto To 12 pin connector on Monitor To constant +12vdc To constant +12vdc Factory Door ajarswitch or BodyControl computer Factory Dome light circuit Positive Switched Dome lighting CONNECTING THE DOME LIGHTS The dome lights in...

Page 10 - Negative Switched Dome lighting; connector

Troubleshooting: SYMPTOM: No power at Video Monitor P o w e r b u t n o v i d e o o rsound Picture, but no sound No Infrared remote func-tions for VCP (or other com-ponents) REMEDY: -Verify +12 VDC on Red wire at 2 pin Power Harness behind video monitor.Verify ground connection with continuity test ...

Page 11 - NOTES