Page 3 - Rear Panel Feature
Rear Panel Feature 1) Left RCA Out: Hook-up for left audio out (white female RCA jack)2) Right RCA Out: Hook-up for right audio out (red female RCA jack)3) Video Out: Hook-up for video out (yellow female RCA jack)4) Power Harness Connection: This plug connects to the power harness mating plug5) Opti...
Page 4 - Front Button Panel Features
Front Button Panel Features 1) Power: This button turns the VOH1332 on and off. Dimly lit when in stand-by mode.2) Channel ∆ ∇ : Pressing ∆ will select higher programmed channels and pressing ∇ will select lower programmed channels than current channel. 3) Volume ∆ ∇ : Pressing ∆ will raise the volu...
Page 5 - General Installation Approach; Notes
General Installation Approach 1) Before beginning installation, please refer to warning on page 10.2) Decide upon system configuration and options that will be installed (ie: what components, VCP, remote headphones, 2 nd VCP, etc.). 3) Review all manuals to become familiar with electrical requiremen...
Page 7 - Wiring Diagram Hook Up Procedure
Wiring Diagram Hook Up Procedure Stereo Headphone Jack Spade Terminals Gray (Left+) Stereo Headphone Jack Optional Remote Headphone Stations Spade Terminals Spade Terminals Black(Ground) Green (Right+) Red: +12 VDC (Accessory Cir.) Black: Ground Power Harness Item 1 Power Connector (2-pin) Antenna T...
Page 8 - Source Component Harness Hook Up
Source Component Harness Hook Up 8 Connector Power (4-Pin) VCP (Rear View) Red RCA Video In YellowRCA R- Audio In White RCA Installations Non-Stereo For Use w/ Adapter Audio "Y" L- Audio In IR LED: Clean the IR window on the front of the VCP, remove the adhesive backing and apply the IR LED ...
Page 9 - Remote Control Functionality
Remote Control Functionality 9 TELEVISION CONTROLS:1) TV Power: Turns unit on/off 2) TV/Video: Toggles between 3 available sources; Tuner/VCP/DVD (VCP2) 3) Mute: Mutes headphone audio 4) 0-9: Numbers for channel selection 5) ∆ CH: Channel Up 6) ∇ CH: Channel Down 7) ∆ Vol: Volume Up 8) ∇ Vol: Volume...
Page 10 - Screw Boss
Cut-Away View of Mounting Bosses Note: If longer screws are substituted, care should be taken to prevent piercing the roof, and besure that pan head screws and washers are used to prevent screws from pulling through thescrew boss. Eight screws must be used and secured to solid structure when mountin...
Page 11 - Troubleshooting
Troubleshooting Symptom: Cause: Possible Solution: Picture scrolls or is fuzzy Antenna type or location Change antenna or tryantenna in a different location Poor Reception Vehicle is moving Not receiving certain channels Connections Vehicle may be outside of TVsignal range.Check antenna connections....
Page 12 - Specifications; Warning
Specifications Video System: NSTC Analog Composite Video (1V P-P, 75 Ω ) A/V Switching: 3 channelsPower: 10-16 VDC, Negative GroundAux Audio Outputs: Left and Right Variable (800mV max, 8 Ω load min.) Left and Right Fixed (300mV typical, 600 Ω load min.) Current Consumption (stand-by mode): 67mACurr...