Page 2 - Please be advised that the wireless FM modulator will
An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD ...
Page 3 - Optional Accessories; MATERIALS INCLUDED IN THIS PACKAGE:
3 TOOLS REQUIRED: #2 Phillips Screwdriver#1 Phillips ScrewdriverUtility or Razor Knife or ShearsWire StrippersUpholstery hook tool (for removal of panels as necessary)Electrical TapeMasking TapeMultimeter (to verify 12 volt DC and continuity: Do not use a test light or logic probe)Marker pen - to ma...
Page 6 - GENERAL INSTALLATION APPROACH:; should be done now as well.
6 GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Video Game, external amp, wireless headphones, VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups. 3) Decide upon mounting ...
Page 7 - Removal of the vehicle's dome light; TRIM RING INSTALLATION:; Using the handle of a screwdriver, make a
7 4) Once the mounting location of the monitor has been determined, there may be additional preparation work necessary, depending on the vehicle structure and installation method. Some of the steps that may be required are:A) Removal of the vehicle's dome light B) If the trim ring will be used, it m...
Page 8 - MOUNTING THE TRIM RING; Make the connections to the vehicle for the 12 pin wiring harness.
8 MOUNTING THE TRIM RING Roof Roof Support Headliner Mounting Bracket Self-drilling Screws Trim Ring Video Unit M5 Screw VOD86 1) Make the connections to the vehicle for the 12 pin wiring harness. , 2) Connect power harness to vehicle s electrical system by tapping into an accessory hot line and a g...
Page 9 - Figure A
VOD86 9 Figure A * Optional Relay Box SIRSWB Auxillary Video Display 12 Pin Power /Signal harness 2 Pin Power Wire Harness with choke L in e O u t- R ( R e d ) L in e O u t- L ( W h it e ) L in e O u t- V ( Y e llo w ) L in e O u t- R ( R e d ) L in e O u t- L ( W h it e ) L in e O u t- V ( Y e llo ...
Page 11 - Negative Switched Dome Lighting; No power at Video Monitor; Press Auto Program button. Then press CH up or CH; No Infrared remote functions; Check batteries in the hand held remote. Verify that the IR
Troubleshooting: 11 Negative Switched Dome Lighting Red / black - Lamp on To 12 pin connector To constant To constant Black / red - Lamp commonPurple / brown - Lamp Auto Factory Door ajarswitch or BodyControl computer SYMPTOM: REMEDY: No power at Video Monitor Verify +12 VDC on Red wire at 2 pin Pow...
Page 12 - WWW
128-8343 2008 Audiovox Electronics Corp. 150 Marcus Blvd. Hauppauge, NY 11788 C WWW