Audiovox VOD806 - Manuals - manualsarea.com

Page 2 - Important Notice

Important Notice It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that is located in the motor vehicle at any point forward of the back of the driver's seat, or that is visible directly or indirectly to the operator of th...

Page 3 - MATERIALS INCLUDED IN THIS PACKAGE:

-1- TOOLS REQUIRED: #2 Phillips Screwdriver#1 Phillips ScrewdriverUtility or Razor Knife or ShearsWire StrippersUpholstery Hook Tool (for removal of panels as necessary)Electrical TapeMasking TapeMultimeter (to verify 12 volt DC and continuity: Do not use a test light or logic probe)Marker – to mark...

Page 4 - GENERAL INSTALLATION APPROACH:; their respective locations.; GENERAL SYSTEM CONFIGURATIONS:; Notes: There are a few audio output options can be added as follows:

GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Tuner, RF Modulator/external amp, remote headphones, 2 nd VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups.3) Decide upon m...

Page 5 - FULL SIZE CONSOLE INSTALLATION

-3- VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v whenkey is off). Also locate a good grounding point. Generally, these connection points can be found atthe Ignition Switch, Fusebox, Radio etc. 2) The mounting method and location wil...

Page 6 - MINI CONSOLE INSTALLATION:; Lowest point mark

MINI CONSOLE INSTALLATION: This page only covers special installation considerations for the mini-console installation.If the video monitor is to be installed in a vehicle with the mini console, the console may need to betrimmed to fit the contour of the vehicle headliner. 1) In this installation, t...

Page 7 - MOUNTING THE MINI-CONSOLE; Roof

-5- MOUNTING THE MINI-CONSOLE Roof Roof Support Headliner 12"x9"x3/4" PlywoodBlock (4) Self-Tapping Screws (not supplied) Mini-Console Video Unit (5) #8 Flat Washers (5) #8x3/4" Self-Tapping Screws (1) Rubber Plug

Page 8 - Sold Separately

1) Make the connections to the vehicle for the 12 pin wiring harness.2) When connecting an AV Component, insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.Pull the wire tie loop tight and c...

Page 9 - CONNECTING THE DOME LIGHTS; Factory Dome light circuit; Positive Switched Dome lighting

CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are twocommon types of dome light circuits used, positive or negative switched. Positive systems supply voltageto the interior lights to turn them on, negative switched systems ap...

Page 10 - on the remote control until sound; Negative Switched Dome lighting; connector

Troubleshooting: SYMPTOM: No power at Video Monitor P o w e r b u t n o v i d e o o rsound Picture, but no sound Static on TV Stations(Tuner Version Only) No Infrared remote func-tions for VCP (or other com-ponents) REMEDY: -Verify +12 VDC on Red wire at 2 pin Power Harness behind video monitor.Veri...