Audiovox VOD705 - Manuals - manualsarea.com

Page 2 - Important Notice

Important Notice It is unlawful in most jurisdictions for a person todrive a motor vehicle which is equipped witha television viewer or screen that is locatedin the motor vehicle at any point forward ofthe back of the driver's seat, or that is visibledirectly or indirectly to the operator of themoto...

Page 3 - MATERIALS INCLUDED IN THIS PACKAGE:

MATERIALS INCLUDED IN THIS PACKAGE: 1) VOD705 DL DVD Video Monitor (P/N 136D2136) (1 pc) 2) Accessory 8 pin FM Transmitter Harness with Transformer (P/N 112B3106) (1 pc) 3) 18 Pin Power / Signal Harness with Two DIN Connectors and Cable Clamps (P/N 1123107) (1 pc) 4) 2 Pin Power Wire Harness with Ch...

Page 4 - GENERAL INSTALLATION APPROACH:; their respective locations.; GENERAL SYSTEM CONFIGURATIONS:

GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Tuner, RF Modulator/external amp, remote headphones, 2 nd VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups.3) Decide upon m...

Page 5 - FULL SIZE CONSOLE INSTALLATION

VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v whenkey is off). Also locate a good grounding point. Generally, these connection points can be found atthe Ignition Switch, Fusebox, Radio etc. 2) The mounting method and location will va...

Page 6 - MINI CONSOLE INSTALLATION:; Lowest point mark

MINI CONSOLE INSTALLATION: This page only covers special installation considerations for the mini-console installation.If the video monitor is to be installed in a vehicle with the mini console, the console may need to betrimmed to fit the contour of the vehicle headliner. 1) In this installation, t...

Page 7 - MOUNTING THE MINI-CONSOLE; Screws

Roof Roof Support Headliner 12"x9"x3/4" PlywoodBlock (4) Self-Tapping Screws (not supplied) Mini-Console Video Unit MOUNTING THE MINI-CONSOLE (5) #8 Flat Washers -5- (5) #8x3/4" Self-Tapping Screws (1) Rubber Plug

Page 8 - Sold Seperately

1) Make the connections to the vehicle for the 18 pin wiring harness (Source Component Harness(s), Power Harness ect.) 2) Connect the 18 Pin Harness to the mating connector on the Video Monitor.3) If required, plug the Source Component Harness(s) into the Din Connection(s) on the 18 Pin Harness (sna...

Page 9 - CONNECTING THE DOME LIGHTS; Factory Dome light circuit; Positive Switched Dome lighting

CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are twocommon types of dome light circuits used, positive or negative switched. Positive systems supply voltageto the interior lights to turn them on, negative switched systems ap...

Page 10 - on the remote control until sound; Negative Switched Dome lighting

Troubleshooting: SYMPTOM: No power at Video Monitor P o w e r b u t n o v i d e o o rsound Picture, but no sound No Infrared remote func-tions for VCP (or other com-ponents) REMEDY: -Verify +12 VDC on Red wire at 2 pin Power Harness behind video monitor.Verify ground connection with continuity test ...