Audiovox VOD702 - Manuals - manualsarea.com

Page 2 - Important Notice; It is unlawful in most jurisdictions for a person

Important Notice It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that islocated in the motor vehicle at any point forward of the back of the driver's seat, or that is visible directly or indirectly to the operator of the...

Page 3 - MATERIALS INCLUDED IN THIS PACKAGE:; ) Hardware Package

MATERIALS INCLUDED IN THIS PACKAGE: 1) VOD701 (136D3428) Video Monitor with DVD (1pc) / VOD702 (136D3429) TV/Video Monitor with DVD (1 pc)2) 12 Pin Power / Signal harness (P/N 112B2821) (1 pc)3) 3 Pin Power Wire Harness with choke (P/ N 112B3274) (1 pc)4) Aux-In pigtail (112B3227 5) Hardware Package...

Page 4 - GENERAL INSTALLATION APPROACH:; their respective locations.; GENERAL SYSTEM CONFIGURATIONS:; -All wiring necessary is included with this package.

GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Video Game, external amp, wireless headphones, VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups.3) Decide upon mounting loc...

Page 5 - ) will be used, it will have to be trimmed to fit the

VEHICLE PREPARATION: 1) Locate a constant power source (+12v at all times), an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good ground generally, thesewires can be found at the ignition switch or fuse-box. 2) The mounting method and loc...

Page 6 - MINI CONSOLE INSTALLATION:; Lowest point mark

MINI CONSOLE INSTALLATION: This page only covers special installation considerations for the mini-console installation. If the videomonitor is to be installed in a vehicle with the mini console (P/N 102C3916 ), this console may need to betrimmed to fit the contour of the vehicle headliner. 1) In thi...

Page 7 - MOUNTING THE MINI-CONSOLE

Roof Roof Support Headliner 5"x9"x3/4" PlywoodBlock or OptionalVOHBKT (4) Self drilling screws (not supplied) Mini-Console Video Unit (4) #8 flat washers (4) #8x3/4" self tapping screws -5- MOUNTING THE MINI-CONSOLE

Page 8 - Figure A; the main PCB and into the Mini-Din Connector on the main PCB.; Note

Figure A 1) Make the connections to the vehicle for the 12 pin wiring harness and battery wire.2) Open the cover to gain access to Mini-Din Connector on main PCB.3) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din ...

Page 9 - Figure B

-7- VOD702 Figure B 1) Make the connections to the vehicle for the 12 pin wiring harness and battery wire.2) Open the cover to gain access to Mini-Din Connector on main PCB.3) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into th...

Page 10 - to wire this package as outlined below.; Using an Audiovox SIRIUS satellite receiver; FM modulator is built in to the receiver).; Using an Audiovox XM satellite receiver; is external to the XM receiver.

VOD701/VOD702 INSTALLATION INSTRUCTIONS WHEN USING SATELLITE RADIO The VOD701/702 pods have dual IR transmitters. Channel A handles normal audio program materialfrom A/V sources (DVD/AUX/TV, etc). The second B channel allows an external audio source suchas Satellite Radio or a CD changer to be used ...

Page 11 - Factory Dome light circuit; Positive Switched Dome lighting; CONNECTING THE DOME LIGHTS; This is the switching wire.

Red / black - Lamp on Black / red - Lamp common Purple / brown - Lamp Auto To 12 pin connector on Monitor To constant +12vdc To constant +12vdc Factory Door ajarswitch or BodyControl computer Factory Dome light circuit Positive Switched Dome lighting -9- CONNECTING THE DOME LIGHTS The dome lights in...

Page 12 - black wire at 2 pin Power Harness; Negative Switched Dome lighting; connector

Troubleshooting: SYMPTOM: No power at Video Monitor P o w e r b u t n o v i d e o o rsound Picture, but no sound S t a t i c o n T V S t a t i o n s (Tuner Version Only) No Infrared remote func-tions for VCP (or other com-ponents) REMEDY: -Verify +12 VDC on Red wire at 2 pin Power Harness behind vid...