Audiovox VOD 808 - Manuals - manualsarea.com

Page 2 - IMPORTANT

IMPORTANT An LCD panel and/or video monitor may be installed in a motor vehicle andvisible to the driver if the LCD panel or video monitor is used for vehicleinformation, system control, rear or side observation or navigation. If theLCD panel or video monitor is used for television reception, video ...

Page 3 - MATERIALS INCLUDED IN THIS PACKAGE:

-1- TOOLS REQUIRED: #2 Phillips Screwdriver#1 Phillips ScrewdriverUtility or Razor Knife or ShearsWire StrippersUpholstery Hook Tool (for removal of panels as necessary)Electrical TapeMasking TapeMultimeter (to verify 12 volt DC and continuity: Do not use a test light or logic probe)Marker – to mark...

Page 4 - GENERAL INSTALLATION APPROACH:; their respective locations.; GENERAL SYSTEM CONFIGURATIONS:; Notes: There are a few audio output options can be added as follows:

GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, Satellite Radio, VCP, Tuner, RF Modulator/external amp, remote headphones, 2 nd VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups...

Page 5 - FULL SIZE CONSOLE INSTALLATION

-3- VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v whenkey is off), constant power source (+12 Vdc at all times). Also locate a good grounding point.Generally, these connection points can be found at the Ignition Switch, Fusebox, Radi...

Page 6 - MINI CONSOLE INSTALLATION:; Lowest point mark

MINI CONSOLE INSTALLATION: This page only covers special installation considerations for the mini-console installation.If the video monitor is to be installed in a vehicle with the mini console, the console may need to betrimmed to fit the contour of the vehicle headliner. 1) In this installation, t...

Page 7 - MOUNTING THE MINI-CONSOLE; Roof

-5- MOUNTING THE MINI-CONSOLE Roof Roof Support Headliner 12"x9"x3/4" PlywoodBlock (4) Self-Tapping Screws (not supplied) Mini-Console Video Unit (5) #8 Flat Washers (5) #8x5/8" Self-Tapping Screws (1) Rubber Plug

Page 8 - stant battery line and also a ground.

1) Make the connections to the vehicle for the 12 pin wiring harness.2) When connecting an AV Component, insert the Circular Mini-Din Connector of the source compo- nent harness through the wire tie loop on the main PCB and into the Mini-Din Connector on themain PCB. Pull the wire tie loop tight and...

Page 9 - CONNECTING THE DOME LIGHTS; Factory Dome light circuit; Positive Switched Dome lighting

CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are twocommon types of dome light circuits used, positive or negative switched. Positive systems supply voltageto the interior lights to turn them on, negative switched systems ap...

Page 10 - on the remote control until sound; Negative Switched Dome lighting; connector

Troubleshooting: SYMPTOM: No power at Video Monitor P o w e r b u t n o v i d e o o rsound Picture, but no sound Static on TV Stations(Tuner Version Only) No Infrared remote func-tions for VCP (or other com-ponents) REMEDY: -Verify +12 VDC on Red wire at 2 pin Power Harness behind video monitor.Veri...

Page 11 - This page blank intentionally