Page 2 - YOUR SPREAD SPECTRUM “CODE HOPPING“ TRANSMITTERS; will not
128-8842 2 of 20 Page 2 Additional Engine Immobilizer Output, (Optional Relay Required) True Last Door Arming (Hardwire Only) Defective Zone By-Pass Defective Zone Chirp Confirmation (Unit Chirps To Report Zone Cleared) 6 Tone Mini Siren Car Horn Output For Additional Alarm Response (Imp...
Page 4 - PROTECTION WHILE THE SYSTEM IS ARMED
128-8842 4 of 20 Page 4 Doors Lock - Optional NOTE: If the optional Headlamp illumination feature has been added and has been selected for operation when arming, as an added convenience, the sys-tem will turn on the headlights when the system is armed.The LCD Remote has the following response: ARM...
Page 5 - SILENT DISARMING
128-8842 5 of 20 Page 5 DISARMING THE SYSTEMNOTE: If the optional 2 step door unlock circuit is installed, when the unlock transmitter button is activated, the drivers door only will unlock, pressing theunlock button a second time will cause all doors to unlock. NOTE: If your transmitter has been co...
Page 8 - MANUALLY OVERRIDING YOUR SYSTEM: USING THE CUSTOM CODE OVERRIDE; The siren will sound.; ELIMINATING THE NORMAL ARM/DISARM CHIRPS
128-8842 8 of 20 Page 8 1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. 2. Turn the ignition switch to the on position.3. Within 10 seconds, press and release the Receiver,s Push-button switch, 3 times. 4. Within 10 seconds turn the ignition switch off, ...
Page 10 - PUSH- BUTTON LED RECEIVER SAFETY CONTROL SWITCH; The System is in the Remote Start Override mode
128-8842 10 of 20 Page 10 4. Stage 3 (City Mode) In this mode, the pre-detect chirps will change from six pre-warning tones to a full 10 seconds of warning chirps. The full detect trigger duration will be reduced from 30 seconds to 15 seconds. NOTE: Setting the stage of the shock sensor will be effe...
Page 13 - TURBO TIMER MODE
128-8842 13 of 20 Page 13 Right Or Left Slider Doors in An Equipped Van Driver Priority Settings In Vehicles So Equipped To activate the optional accessory, press the option button on the keychain transmitter. The optional accessory will immediately engage. ADDITIONAL REMOTE FUNCTION (CHANNEL 7)...
Page 14 - TRANSCEIVER ICONS AND THEIR INDICATIONS
128-8842 14 of 20 Page 14 TRANSCEIVER ICONS AND THEIR INDICATIONS When Disarmed, Press the Arm/Lock button to Lock and Arm the System. The Lock Icon is displayed on the LCD panel & the parking lights flash once. When Armed, Press the Disarm/Unlock button toUnlock and Disarm the System. The Unloc...
Page 15 - ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:; The Extended range transmitter(s) will only achieve the maximum; PROGRAMMED TRANSMITTER NOTIFICATION (PTN)
128-8842 15 of 20 Page 15 or Trunk. Triggered and entry attempt was made to the vehicles glass, orthe vehicle has been hit or bumped hard enough to cause aresponse from the vibration detector. ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE: If the arm/disarm chirp tones have been turned off at the vehic...
Page 16 - NOTE
128-8842 16 of 20 Page 16 ADDITIONAL REMOTE FEATURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display, toggle the transmitter from beep tones to vibrate mode, initiate daily start timer, and temperature start. Selection o...
Page 18 - Temperature Start Mode.
128-8842 18 of 20 Page 18 Battery Indicator: Your transmitter has a battery indicator that is shown in the lower left corner of the screen as shown left. This icon indicates a charged battery shown with 3 bars. As the battery discharges, the bars will disappear. 1 bar indicates the battery needs cha...
Page 20 - * These chirps are optional and can be selected off.; PARKING LAMP INDICATORS; FLASH
128-8842 20 of 20 Page 20 © 2010 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-8842 SS9000 SYSTEM FUNCTIONS AT A GLANCE LED INDICATOR RAPID FLASHING = PASSIVE ARM OR REARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 2 SHORT,,, 1LONG = REMOTE START OVERRIDE 3...