Page 2 - Notes on CDs
1 * Tracks from 6 CDs stored in the disc magazine can be selected and played. * Horizontal, vertical, angled and suspended installation. * Do not install the unit in a location where it may be subjected to : - direct sun or other forms of excessive temperature. - excessive heat. - fluid, rain or moi...
Page 3 - Notes on the disc magazine
2 * Do not expose the discs to direct sunlight or excessive heat. * Clean the discs before inserting them into the disc magazine. Always clean a disc from center outward with a cleaning cloth. * Never use solvents such as benzine or alcohol to clean a disc. * You cannot play an 8cm(3 inch) CD even w...
Page 4 - Insert the magazine firmly
3 1. * Pull out the slot by pulling the part with finger. * With the label side up, insert a CD all the way 6 discs, one in each slot * Push slot and close it. 3. Insert the magazine firmly (which has been taken out of the unit) with the mark visible on the top side. * Press the eject button and pul...
Page 5 - Precautions; the mounting surface.; Supplied mounting kit
4 Precautions Select the mounting location very carefully by referring to the following points * Make sure that there is not a fuel tank, wiring or piping on the other side of the mounting surface. * Make sure that the installation of the unit will not hinder the movement of the trunk lid or interfe...
Page 6 - Installing the unit; s mechanism during transport.
5 Installing the unit M o u n t i n g a n g l e s e t t i n g l e v e r Be sure to adjust Mounting Angle S e t t i n g L e v e r ( A ) t o a p p r o p r i a t e a n g l e ; 0 ° f o r h o r i z o n t a l , 2 2 . 5 ° angle, 45 ° angle, 67.5 angle, 80 ° angle, or 90 ° for vertical. R e m o v i n g t h ...
Page 7 - Horizontal installation; Construction; Note; A b o u t p a r t s n u m b e r s; a n g l e d i n s t a l l a t i o n
6 After adjustment, be sure to attach the Double side Tape . Note Do the same procedure on the other side of the unit. Horizontal installation Construction Removing temporarily Making holes on the carpet Completion Note A b o u t p a r t s n u m b e r s ❶ ❷ ❺ ❻ ❼ ❽ , r e f e r t o p a g e 4 . a n g ...
Page 8 - Vertical installation; Removing temporarily; About parts numbers
7 Vertical installation 1. Construction 2. Removing temporarily 3. Making holes on the carpet 4. Completion Note About parts numbers ❶ ❷ ❺ ❻ ❼ ❽ , refer to page 4.
Page 9 - Suspended installation
8 Suspended installation When installing the unit in the t r u n k u n d e r t h e r e a r w i n d o w s h e l f , o b s e r v e t h e f o l l o w i n g . - M a k e s u r e t h a t t h e u n i t i s suspended horizontally. - Select the mounting location carefully so that the unit does n o t h i n d ...
Page 10 - General
9 W h e n c o n n e c t i n g , r u n t h esupplied connecting cable andc o n n e c t t o A u d i o v o x m o d e lPAV-9 as illustrated here. Caution Make sure to disconnect the groundwire terminal of the car battery beforem a k i n g a c o n n e c t i o n i n o r d e r t oprevent short circuiting. ...
Page 11 - PRINTED IN KOREA; 2 MONTH LIMITED WARRANTY
PRINTED IN KOREA 12 MONTH LIMITED WARRANTY Applies to Audiovox Video products AUDIOVOX ELECTRONICS CORPORATION (the Company) warrants to the original retailpurchaser of this product that should this product or any part thereof, under normal use andconditions, be proven defective in material or workm...