Audiovox RVMPKG4 - Manuals - manualsarea.com

Page 2 - Warnings

Warnings The product is intended to assist in safe driving and to allow the driver to have a broader rearview while in reverse. You as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers according to the country and their local traffic regulati...

Page 3 - TABLE OF CONTENTS

TABLE OF CONTENTS Warnings 1 Product description 3 Packing list 3 Installation Instructions 4 1. Signal Input 5 2. Control and Indicator 6 3. Auxiliary Input Switch 7 Specifications 7 Maintenance 8 Troubleshooting 9 Illustration of connections 10 2

Page 4 - Product Description; Backing up vehicle; Packing list

Product Description There is a blind spot that exists at the back of a vehicle while the vehicle is in reverse. Equipped with a camera, this electronic rearview mirror provides the driver with a clear and wide image of the area behind the vehicle whenever the vehicle is shifted into reverse. Backing...

Page 5 - Camera; Installation Instructions

5 Rear View CMOS1 Camera Parts list included with camera installation manual 6 Camera Cable 1. Installation Instructions (1) Mount the mirror/monitor a). Take the two belts and slide them into the slots on the top rear of the mirror with the grooved side of the belt facing down. Figure 1 b). Take th...

Page 6 - (3) Connect the mirror cable and power cable as shown in Figure 6

d). Trim off excess length of the straps. e). Place (hide) the monitor cable behind the windshield trim piece down under the dash area. (2) Wiring the Monitor a) RED FUSED WIRE: 12VDC ACCESSORY SOURCE Connect this wire to a source that has 12 volts when the Ignition key switch is turned on, and 0 vo...

Page 7 - Controls and Indicators

Figure 4 3. Controls and Indicators Figure 5 Figure 5 illustrates the controls and indicators of the RVMPKG4(V2.0) rear view mirror: A : Rearview mirror B : 4" LCD panel C : Brightness control knob D : Power indication (Red when ignition is on) 6

Page 8 - Auxiliary Input Switch; Specification

E : Speaker volume control F : Auxiliary input switch (see below) G : Speaker in rear of mirror Auxiliary Input Switch : Auxiliary input switch: To access the 2 nd A/V input press the switch. Note: The parking brake must be engaged in order to view the 2 nd input. Specification General Power Supply ...

Page 9 - Maintenance; Though your Rearview mirror requires little care, you can still

Maintenance Though your Rearview mirror requires little care, you can still maintain its condition and performance following the procedures below. • Keep your system away from excessive moisture, extreme heat or cold and magnetic fields. • Keep liquids away from the display mirror. • To avoid damage...

Page 10 - Troubleshooting

Troubleshooting Symptoms Solutions The ON/OFF signal light <D> is not on after the car is started? 1. Check the installation-wiring diagram. 2. Ensure that the parallel red and black line from the control box is connected properly. No video signal appears while reversing the car? 1. Check the ...

Page 11 - Illustration of Connections

Illustration of Connections Refer to CMOS1 camera installation manual Parts list included with camera 10