Audiovox PRO-9800 - Manuals

Page 2 - YOUR “CODE HOPPING“ TRANSMITTERS

128-6527 2 of 20 Page 2 ! Protected Push Button Valet/Override Switch ! 7-Function LED-Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming ! Intrusion Alert With Memory ! Instant Siren Activation ! Starter Disable Output ! Additional Engine Immobilizer Output, (Optional Relay Required) ! True L...

Page 3 - will not; ARMING THE SYSTEM - ACTIVE

128-6527 3 of 20 Page 3 known as a code grabber, which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system.Your Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then re...

Page 4 - PROTECTION WHILE THE SYSTEM IS ARMED

128-6527 4 of 20 Page 4 " Parking Lights flash one time. " Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the sys- tem detected a open entry point after the learned delay expired....

Page 5 - SILENT DISARMING

128-6527 5 of 20 Page 5 " Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones. " Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle. NOTE: If the optional interior illumination circuit w...

Page 7 - MANUALLY OVERRIDING YOUR SYSTEM:; USING THE VALET SWITCH MANUAL OVERRIDE

128-6527 7 of 20 Page 7 1. Enter the vehicle and turn the ignition key to the on position.2. Press and hold the valet pushbutton switch until the dash mounted LED turns on solid. The system will remain in the valet mode. 3. To return to normal operation, press and release the pushbutton switch any t...

Page 8 - Custom Code Programming Example:

128-6527 8 of 20 NOTE: If 15 seconds of inactivity expire or if the ignition switch is turned off for more then 5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. Custom Code Programming Example: To Change the code from the factory pre-assigned c...

Page 10 - REMOTE STARTING THE VEHICLE

128-6527 10 of 20 2. Stage 1 (Omit pre-detect) In this mode, the warn away chirps created by the lesser vibration will be deleted. If strong vibration occurs, the siren will sound. 3. Stage 2 (Omit pre & full detect) In this mode, both the pre-detect stage and the full trigger stage of the senso...

Page 15 - TRANSCEIVER ICONS AND THEIR INDICATIONS; When Armed, Press the Disarm/Unlock button to

128-6527 15 of 20 Page 15 TRANSCEIVER ICONS AND THEIR INDICATIONS When Disarmed, Press the Arm/Lock button to Lockand Arm the System. The Lock Icon is displayed onthe LCD panel & the parking lights flash once. When Armed, Press the Disarm/Unlock button to Unlock and Disarm the System. The Unlock...

Page 16 - ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:

128-6527 16 of 20 The following trigger patterns will be displayed.Triggered and the entry attempt was made to one ofthe vehicle doors. Triggered and entry attempt was made to the vehicleshood or trunk. Triggered and entry attempt was made to the vehiclesglass, or the vehicle has been hit or bumped ...

Page 20 - SYSTEM FUNCTIONS AT A GLANCE; DASH LED INDICATORS

128-6527 20 of 20 © 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-6527 PRO-9800 SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING/ACTIVE REARMINGSLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 3 FLASH...PAUSE = INTRUSION ZONE 3 2...