Audiovox PRO-9776 - Manuals

Page 2 - YOUR “ CODE HOPPING “ TRANSMITTERS:; will not

128-7856 2 of 12 Page 2 Your Remote Start Alarm System has many features and available options some of whichare selected at time of installation. For your reference, the list on page 9 of this manualshows what features and options have been installed. Consult your installing dealer foroptions that m...

Page 4 - SILENT DISARMING; transmitter for two seconds.; WHILE THE SYSTEM IS SOUNDING

128-7856 4 of 12 Page 4 NOTE: If the optional 2 step door unlock circuit is installed, when the unlock transmitter buttonis activated, the drivers door only will unlock, pressing the unlock button a secondtime will cause all doors to unlock. If your transmitter has a sperate lock unlockbuttons, pres...

Page 5 - Programming Your Custom Override Code:; sequence. Turn the ignition switch to the on position.

128-7856 5 of 12 Page 5 door locks will remain operational. To use the valet mode, the system must first be disarmedeither by using your keychain transmitter, or by activating your personalized manual overridecode.1. Enter the vehicle, and turn the ignition key to the on position.2. Press and hold t...

Page 6 - Custom Code Programming Example:; (The siren or horn will beep and the lights will flash one time.); ELIMINATING THE NORMAL ARM/DISARM CHIRPS

128-7856 6 of 12 Page 6 5 seconds during any of the above steps, the unit will revert back to the lastsuccessfully stored code. Custom Code Programming Example: To Change the code from the factory pre-assigned code of 11 to “52” you would do thefollowing: 1. Disarm the system by use of the transmitt...

Page 7 - REMOTE PANIC OPERATION; seconds. The alarm will immediately sound.

128-7856 7 of 12 Page 7 NOTE: If the vehicle battery is disconnected then reconnected, the unit will return to thedefault setting of chirps on. Repeat the above procedure to eliminate the arm/disarmchirps. REMOTE PANIC OPERATION The Lock or Unlock button on your keychain transmitter also functions a...

Page 8 - REMOTE STARTING THE VEHICLE; The System is in the Remote Start Override mode; To Remote Start The Vehicle:

128-7856 8 of 12 Page 8 The parking lights will flash two times indicating the mode was successfully entered.If your parking lights flashed four times, this indicates the turbo mode was on and is nowturned off.With the turbo timer mode selected on, after you've arrived at your destination, while the...

Page 9 - Remote Trunk Release

128-7856 9 of 12 Page 9 TO BEGIN THE AUTOMATIC START UP TIMER 1. Turn the ignition key on then off.2. Within 10 seconds, activate the RF start command two times. (Push the trunk/key button of your keychain transmitter 4 times). The parking lights will flash and the siren will chirp 4 times indicatin...

Page 12 - SYSTEM FUNCTIONS AT A GLANCE

128-7856 12 of 12 Page 12 ALARM DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 3 FLASH... PAUSE = INTRUSION ZONE 3 2 FLASH...PAUSE = INTRUSION ZONE 2 1 FLASH...PAUSE = INTRUSION ZONE 1 ALARM SIREN CHIRP INDICATION 1 CHIRP* = ARM 2 CHIRP...