Audiovox PRO-9671FT - Manuals

Green w/ White trace Wire: Entry Illumination Ground Output This wire provides a 30 second ground output (300 mA Max.) whenever the remote is used to disarm thealarm or to unlock the doors and provides a continuous pulsed output whenever the alarm is triggered. Thiswire should be connected to an ext...

Orange Wire: Ground When Armed Output This wire provides a 300 mA ground output when the alarm circuit is armed to control the starter inhibitrelay. Connect the Orange wire to terminal #86 (orange wire) of the relay provided. Connect terminal #85(red wire) of the relay to an ignition wire in the veh...

Black Wire: Chassis Ground Source Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Becertain to remove any paint or grease and secure this wire with a self taping screw and ring terminal. Chassis Ground Connection Detail Green w/ Orange Trace Wir...

Dark Blue Wire: Delayed 300mA Pulsed Channel 2 Output The Dark Blue wire supplies a 300mA ground pulsed output whenever channel two of the receiver is accessed.Pressing the pre-programmed transmitter button for three seconds will access channel two. This is a lowcurrent output and must be connected ...

2 Pin Control Switch: (Red Connector) The Black & Black w/White Trace wires loaded in the two pin red connector enable the operation of the Remote Start unit. When the Black w/ White Trace wire is grounded, the remote start unit is operable. When this wire is open from ground, the remote start i...

3 Wire Positive Switched Door Locks: In this application, the Red wire of the two pin harness provides a + 12 volt pulse during the disarmingsequence, or pulsed 12 volt unlock output. Connect the Red wire to the low current 12 volt signal wire fromthe factory door unlock switch to the factory door u...

REMOTE START SELECTABLE FEATURES RF Programmable Features: LED Pattern1 x Pause etc.2 x Pause etc.3 x Pause etc.4 x Pause etc.5 x Pause etc.6 x Pause etc.7 x Pause etc.8 x Pause etc. DefaultOff10 MinutesSteadyTach----------------Off during crankOff--------------- Park Lights Flashes 2 xRF start chir...

KEY IN SENSOR CIRCUITS: If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there are two alternatives available. Although not preferred, the vehicle Key In Sensor may be reconfigured to allow a margin of safety and will prevent the vehicle with a Mechanical ...

METHOD 2 To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin switch to the key in sensor switch.B. Cut this wire and connect the ignition cylinder side to chassis ground.C. Locate the key in sensor switch wire that connects the ...

OUTPUT GREEN/BLACK (-)TO CHANNEL 3 CONTROL RELAY GREENRED DOOR LOCKS (See page 13) REDBLUE L.E.D. (See page 13) BLUE RED GREEN BLACK SHOCK SENSOR (See page 13 & 14) BLACK BLACK w/WHITE CONTROL SWITCH (See page 13) WIRING DIAGRAM GRAY BLACK w/GRAY VALET/PROGRAMMING SWITCH (See page 13) AUXILIARY ...