Audiovox PRO-9556 - Manuals

Audiovox PRO-9556 – Manual in PDF format online.

Manuals:

Manual

Manual Audiovox PRO-9556

Summary

Page 2 - To program these selectable features

128-7770 2 of 20 To program these selectable features; Action System Response Turn ignition on No response Press and release the valet switch 3 times 1 Chirp - LED 1 flash Within 3 seconds, turn ignition Off Then On Short chirp, then long chirp This Action Accesses Feature Bank 2 Alarm Selectable Fe...

Page 5 - INSTALLATION OF THE MAJOR COMPONENTS:; PUSH-BUTTON LED SWITCH; The Remote Start System is to be used in vehicles with; AUTOMATIC TRANSMISSIONS

128-7770 5 of 20 This Remote Start/Keyless Entry System is designed for use with Automatic Transmission Vehicles Only! Theunit provides wait to start input for glow plug pre-heat which will be used for all diesel applications. If this wire isnot connected, then the unit will remain in the Gasoline m...

Page 6 - Starter Output

128-7770 6 of 20 6 THE RECEIVER/ANTENNA ASSEMBLY: The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the dashboardfor maximum operating range. Choose a location above the belt line (dashboard) of the vehicle for best reception.Special considerations must ...

Page 7 - SEE NEUTRAL START SAFETY TEST FOR FURTHER DETAILS.; Ignition 1 Output

128-7770 7 of 20 NOTE: This wire must be connected to the vehicle side of the starter cut relay (when used). For the electrical neutralswitch configuration, this connection must be made between the starter inhibit relay, (when used) and theneutral safety switch as shown in the following diagram. Fai...

Page 8 - Accessory Output; WIRING CONNECTIONS: 12 Pin Input / Output Harness; Chassis Ground Source

128-7770 8 of 20 VIOLET WIRE: Accessory Output Connect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the ignitionswitch is turned to the "ACCESSORY" or "ON" and "RUN" positions and will show 0 volts when the key is turned to the...

Page 9 - Brake Switch Positive Shutdown Detail; Ignition 3 / Shock Disable Output

128-7770 9 of 20 Brake Switch Positive Shutdown Detail YELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass Output NOTE: You must disconnect the ignition input of the alarm from any other wire that it is presently connected to in the vehicle.This wire provides a + 12 Volt output when the ignition ...

Page 10 - General Motors VATS By-Pass Diagram; Tach Sensor Input

128-7770 10 of 20 A. Shock Sensor By Pass: If there is Shock Sensor used with an alarm system and it is not shunted during the Remote Start activation period,then vibration from the running vehicle can cause the alarm to trigger. In this case, connect the Light Blue Wire toterminal #86 of a external...

Page 11 - Tachometer Input Wiring Detail; Diesel Wait To Start Input; WIRING THE 4 PIN AUXILIARY OUTPUT HARNESS; Pulsed Ground Output Before Start; Push-Button LED Programming Switch Assembly:

128-7770 11 of 20 Tachometer Input Wiring Detail 11 Green/Yellow Wire: Diesel Wait To Start Input The Green/Yellow wire of the 2 pin connector will connect to a diesel vehicles glow plug wire. When the unit receivesa start command, this wire must go to + 12 then to ground to allow the crank sequence...

Page 12 - Wire Ground Switched Door Lock Circuits:; Wire Ground Switched Door Lock/Unlock Wiring Detail; Wire Positive Switched Door Locks:; Wire Positive Switched Door Lock/Unlock Wiring Detail

128-7770 12 of 20 The Red & Green Door Lock/Unlock output wires provide either a pulsed ground or pulsed + 12 volts to control thevehicle door lock / unlock circuits. The output of these wires has a maximum switching capability of 300mA. Manyvehicles today have factory door lock relays which can...

Page 13 - Pin Blue Connector :; Programming Switch; Multi Coil Pack Adapter:

128-7770 13 of 20 13 nience, the AS 9159a Door Lock Interface. Refer to the AUDIOVOX Door Lock Wiring Supplement and or the Audiovoxfax back service for information on your particular vehicle for properly connecting to these types of circuits. 2 Pin Blue Connector : Programming Switch Route the gray...

Page 14 - cylinder, four coil systems, connect to any of the three coils.

128-7770 14 of 20 14 cylinder, four coil systems, connect to any of the three coils. 3. Connect the Yellow wire to a +12 volt ignition 1 source. This wire will have +12 volts with the ignition in the on and start position and have 0 volts with the ignition in the off position. 4. Connect the Green w...

Page 15 - switch off. DO NOT attempt to remove the key.; REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILY; MECHANICAL NEUTRAL SAFETY SWITCH CONSIDERATIONS:

128-7770 15 of 20 1. Set the vehicle parking brake.2. Block the drive wheels to prevent vehicle movement.3. Temporarily disconnect the Brown/Black positive shut down wire from the vehicle's brake switch.4. Sitting in the vehicle, start the engine using the vehicle's ignition key.5. Step on the brake...

Page 16 - KEY IN SENSOR CIRCUITS:; Method 1; METHOD 1

128-7770 16 of 20 KEY IN SENSOR CIRCUITS: If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there are two alternativesavailable. Although not preferred, the vehicle Key In Sensor may be reconfigured to allow a margin of safety and willprevent the vehicle wi...

Page 17 - METHOD 2

128-7770 17 of 20 METHOD 2 To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin switch to the key in sensor switch.B. Cut this wire and connect the ignition cylinder side to chassis ground.C. Locate the key in sensor switch wire ...

Page 18 - COMPLETING THE INSTALLATION:; under the dash board or in the engine compartment areas.; point these out to the customer.

128-7770 18 of 20 COMPLETING THE INSTALLATION: After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety features of thesystem: 1. If you have not done so already, place the red rubber handle cover over the handle of the control switch for ease of identificat...