Audiovox MM850 - Manuals - manualsarea.com

Page 2 - Installation Guide; Important Notice

Installation Guide 2 Important Notice An LCD panel and/or video monitor may be installed in a motor vehicle and visible to thedriver if the LCD panel or video monitor is used for vehicle information, system control,rear or side observation or navigation. If the LCD panel or video monitor is used for...

Page 3 - MATERIALS INCLUDED IN THIS PACKAGE:; – 7 pcs

Installation Guide 3 MATERIALS INCLUDED IN THIS PACKAGE: 1) MM850 Video Monitor (P/N 136-3869) – 1pc 2) Trim Ring (P/N 102C4007) – 1pc 3) Remote Control (P/N : 136B3650) – 1pc 4) Hardware Package:- ♦ #4 x 5/16” Screws – 7 pcs ♦ #8 x 5/8” Self Drilling Screws – 4 pcs ♦ #8 Washers – 4 pcs 5) 2 Pin Pow...

Page 4 - GENERAL INSTALLATION APPROACH:; their respective locations.

Installation Guide 4 GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Tuner, RF Modulator/external amp, remote headphones, DVD, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups....

Page 5 - The headliner may need to be trimmed.

Installation Guide 5 VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off). Also locate a good ground wire. Generally, these wires can be found at the ignition switch orfuse-box. 2) The mounting method and location will vary...

Page 6 - TRIM RING INSTALLATION:; Cut the trim ring using a Dremel Tool.; Lowest point mark

Installation Guide 6 TRIM RING INSTALLATION: This page only covers special installation considerations for the trim ring installation.If the video monitor is to be installed in a vehicle with the trim ring, it may need to be trimmed to fit thecontour of the vehicle headliner. 1) In this installation...

Page 7 - MOUNTING THE TRIM RING

Installation Guide 7 Roof Roof Support Headliner 5"x9"x3/4" PlywoodBlock (4) #8x1" self drilling screws Trim Ring Video Unit (4) #8 flat washers (4) #8x3/4" self tapping screws MOUNTING THE TRIM RING

Page 8 - on the main PCB and into the Mini-Din Connector on the main PCB.

Installation Guide 8 1) Insert the Circular Mini-Din Connector of the source Component Harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB. 2) Pull the wire tie loop tight and cut off the excess.3) Connect the Power Harness to the mating connector on the...

Page 9 - Positive Switched Dome lighting; CONNECTING THE DOME LIGHTS

Installation Guide 9 Red / black - Lamp on Black / red - Lamp common Violet / brown - Lamp Auto To 3 pin connector on Monitor To constant +12vdc To constant +12vdc Factory Door ajarswitch or BodyControl computer Factory Dome light circuit Positive Switched Dome lighting CONNECTING THE DOME LIGHTS Th...

Page 10 - No power at Video Monitor; Negative Switched Dome lighting

Installation Guide 10 Troubleshooting: SYMPTOM: No power at Video Monitor P o w e r b u t n o v i d e o o rsound Picture, but no sound REMEDY: -Verify +12 VDC on Red wire at 2 pin Power Harness behind videomonitor. Verify ground connection with continuity test from knowngood ground to black wire at ...