Page 3 - TABLE OF CONTENTS
TABLE OF CONTENTS Cautions! 1 Preface 3 Packing list 3 1.Installation Instructions 4 2.Signal Inputs 7 3.Controls and Indicators 9 Specifications 12 Maintenance 13 Troubleshooting 14 Illustration of connections 15 2
Page 4 - Preface; Packing list; Double side adhesive tape –1
Preface This replacement mirror /monitor can display up to 3 different video inputs. The inputs are Navigation, Rear observation camera and Interior observation camera. Not all rearview mirrors attach to the vehicle with the same style mount. Please consult the application guide for the appropriate ...
Page 5 - Instructions; Mount the mirror/monitor; Control box connection:
1. Installation Instructions (1) Mount the mirror/monitor a) Remove the original factory mirror. (Do not use excessive force when removing factory mirror.) Check to make sure that the factory mirror mount you remove matches the mirror mount on the replacement mirror. If it does not match, consult th...
Page 6 - Installing the Temperature Sensor.; Figure 2
(4) Installing the Temperature Sensor. a) Select a suitable location for the Temperature sensor outside of the vehicle. The location should be in the nose area of the vehicle, between the front of the radiator and front bumper where there will be airflow. Keep the sensor as low as possible, and as f...
Page 7 - Note
b ) Secure the Compass sensor using the screw provide or double sided adhesive tape to the selected location with the head of the compass sensor arrowhead facing forward. c ) Route the Compass cable up the A pillar and connect the 5 pin Compass Sensor cable to the mating 5 pin connector of the Tempe...
Page 8 - WARNING: Observe polarity when connecting the wires.
WARNING: Observe polarity when connecting the wires. Figure 4 2. Signal Inputs The signal input connections for the system include: Control BOX To Control BOX Filter BOX Cam Button Selector Switch To Rearview CameraTo Interior Camera To Mirror AssemblyTo Filter BOX Red (+12V) Blue (Ignition) Black (...
Page 10 - Controls and Indicators; “CAM”
Figure 5 3. Controls and Indicators Figure 3 shows the function controls of the rear view mirror. A : 4.5" LCD Panel B : Rearview Mirror Glass C : “+” Button (optional Navigation System required) Incrementally increase volume level of the navigation voice command when pressed. Note: Will only op...
Page 13 - Specifications; General
Specifications General Power Supply 12VDC Power Consumption <12W Current Draw <800mA Video Input 1Vp-p/ 75 Impedance Audio Input <=1V Audio Power Output 0.5W × 1 (16 Ω ) Operating Temperature Range 0 degrees C to 50 degrees C Display System Screen 4.5” TFT Color LCD Brightness 400 cd/ Contr...
Page 14 - Maintenance
Maintenance Though your Rearview mirror requires little care, you can still maintain its condition and performance by following the procedures below. Keep your system away from excessive moisture, extreme heat or cold, and magnetic fields. Keep liquids away from the display and mirror. To avoid dama...
Page 15 - Troubleshooting; Symptoms
Troubleshooting Symptoms Solutions The ON/OFF signal light <E> is not on after the car is started? 1. Check the installation-wiring diagram. 2. Ensure that the parallel red and black line from the control box is connected properly. 3. Check for 12 volts on the blue wire while the ignition on. ...
Page 16 - Illustration of Connections; Figure 8