Audiovox LCM1331FDW - Manuals

Page 3 - Rear Panel Feature

Rear Panel Feature 1) Left RCA Out: Hook-up for left audio out (white female RCA jack)2) Right RCA Out: Hook-up for right audio out (red female RCA jack)3) Video Out: Hook-up for video out (yellow female RCA jack)4) Power Harness Connection: This plug connects to the power harness mating plug5) Opti...

Page 4 - Front Button Panel Features

Front Button Panel Features 1) Power: This button turns LCM1331FD/LCM1331FDW on and off. Dimly lit when in stand-by mode.2) Channel ∆ ∇ : Pressing ∆ will select higher programmed channels and pressing ∇ will select lower programmed channels than current channel. 3) Volume ∆ ∇ : Pressing ∆ will raise...

Page 5 - General Installation Approach; Notes

General Installation Approach 1) Before beginning installation, please refer to warning on page 10.2) Decide upon system configuration and options that will be installed (ie: what components, VCP, remote headphones, 2 nd VCP, etc.). 3) Review all manuals to become familiar with electrical requiremen...

Page 6 - Vehicle Preparation; = Recommended Additional Cutout

Vehicle Preparation 1) Locate vehicle power source. Generally this is best found near the vehicle’s fuse block, which is usually (though not always) under the steering wheel area. Locate an accessory hot circuit to tap into video system power. Accessoryhot means a circuit that is +12VDC when the ign...

Page 7 - Wiring Diagram Hook Up Procedure

Wiring Diagram Hook Up Procedure Stereo Headphone Jack Spade Terminals Gray (Left+) Stereo Headphone Jack Optional Remote Headphone Stations Spade Terminals Spade Terminals Black(Ground) Green (Right+) Red: +12 VDC (Accessory Cir.) Black: Ground Power Harness Item 1 Power Connector (2-pin) Antenna T...

Page 8 - Source Component Harness Hook Up

Source Component Harness Hook Up 8 Connector Power (4-Pin) VCP (Rear View) Red RCA Video In YellowRCA R- Audio In White RCA Installations Non-Stereo For Use w/ Adapter Audio "Y" L- Audio In IR LED: Clean the IR window on the front of the VCP, remove the adhesive backing and apply the IR LED ...

Page 9 - Remote Control Functionality

Remote Control Functionality 9 TELEVISION CONTROLS:1) TV Power: Turns unit on/off 2) TV/Video: Toggles between 3 available sources; Tuner/VCP/DVD (VCP2) 3) Mute: Mutes headphone audio 4) 0-9: Numbers for channel selection 5) ∆ CH: Channel Up 6) ∇ CH: Channel Down 7) ∆ Vol: Volume Up 8) ∇ Vol: Volume...

Page 10 - Screw Boss

Cut-Away View of Mounting Bosses Note: If longer screws are substituted, care should be taken to prevent piercing the roof, and be sure that pan headscrews and washers are used to prevent screws from pulling through the screw boss. Eight screws must be used andsecured to solid structure when mountin...

Page 11 - Troubleshooting

Troubleshooting Symptom: Cause: Possible Solution: Picture scrolls or is fuzzy Antenna type or location Change antenna or try antenna in adifferent location Poor Reception Vehicle is moving Not receiving certain channels Connections Vehicle may be outside of TV signal range.Check antenna connections...

Page 12 - Specifications; Warning

Specifications Video System: NSTC Analog Composite Video (1V P-P, 75 Ω ) A/V Switching: 3 channelsPower: 10-16 VDC, Negative GroundAux Audio Outputs: Left and Right Variable (800mV max, 8 Ω load min.) Left and Right Fixed (300mV typical, 600 Ω load min.) Current Consumption (stand-by mode): 67mACurr...

Page 13 - Optional Product List

Optional Product List Televisions AVT-988 9” Color Television with Remote (12V) AVT988 AVT-1498 13” Color Television with Remote (12V) AVT1498 VCP and DVD Players For use with TV’s and LCD AVP-7000 Video Cassette Player (12V) AVP7000 AVP-7285 Stereo Video Cassette Player (12V) AVP7285 Single Disc DV...