Audiovox AX-900 - Manuals - manualsarea.com

Page 2 - YOUR “CODE HOPPING“ TRANSMITTERS

128-6995 2 of 20 Page 2 Protected Push Button Valet/Override Switch 7-Function LED-Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming Intrusion Alert With Memory Instant Siren Activation Starter Disable Output Additional Engine Immobilizer Output, (Optional Relay Required) True Last Door Armin...

Page 3 - will not; ARMING THE SYSTEM - ACTIVE

128-6995 3 of 20 Page 3 known as a code grabber, which will receive and store the signal from your keychain transmitter and retransmit at a later time to disarm your system.Your Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then ret...

Page 4 - PROTECTION WHILE THE SYSTEM IS ARMED

128-6995 4 of 20 Page 4 Parking Lights flash one time. Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the sys- tem detected a open entry point after the learned delay expired. Clos- ing t...

Page 5 - SILENT DISARMING

128-6995 5 of 20 Page 5 not be started. Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones. Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle. NOTE: If the optional interior illumination circu...

Page 7 - MANUALLY OVERRIDING YOUR SYSTEM:; USING THE VALET SWITCH MANUAL OVERRIDE; override sequence. Turn the ignition switch to the on position.

128-6995 7 of 20 Page 7 the parking lights will flash to indicate locking and unlocking. To use the valet mode, the system must first be disarmed either by using your keychain transmit- ter or by activating your personalized manual override code. 1. Enter the vehicle and turn the ignition key to the...

Page 8 - Custom Code Programming Example:

128-6995 8 of 20 steps 1 through 7 above considering the following. NOTE: Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 (Zero), or no digit entered in any place, units or tenths. NOTE: If 15 seconds of inactivity expire or if the ignition switch is turned off for ...

Page 9 - ELIMINATING THE NORMAL ARM / DISARM CHIRPS

128-6995 9 of 20 5. Turn the ignition switch off then on and start the vehicle. NOTE: If you have changed the programmed override code then substitute your new code tenths for step 2 above, and units for step 5 above. ELIMINATING THE NORMAL ARM / DISARM CHIRPS As explained earlier in the manual, you...

Page 15 - TRANSCEIVER ICONS AND THEIR INDICATIONS; When the Key Icon Button Has Been Operated for 3

128-6995 15 of 20 Page 15 TRANSCEIVER ICONS AND THEIR INDICATIONS When Disarmed, Press the Arm/Lock button to Lockand Arm the System. The Lock Icon is displayed on theLCD panel & the parking lights flash once. When Armed, Press the Disarm/Unlock button toUnlock and Disarm the System. The Unlock ...

Page 16 - icons shown left will appear on the screen.; ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:

128-6995 16 of 20 icons shown left will appear on the screen. If the alarm system has been triggered, the icon dis-played on the transmitter LCD will indicate the whichzone has been activated, as well sound the beep tones,or vibrate dependent upon the setting as shown above.The following trigger pat...

Page 20 - SYSTEM FUNCTIONS AT A GLANCE; DASH LED INDICATORS

128-6995 20 of 20 © 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-6995 AX-900 SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING/ACTIVE REARMINGSLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 3 FLASH...PAUSE = INTRUSION ZONE 3 2 F...