Audiovox APS-55 - Manuals - manualsarea.com

Page 5 - WIRING CONNECTIONS: 12 Pin Input / Output Harness

WIRING CONNECTIONS: 12 Pin Input / Output Harness Black Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Be certain toremove any paint or grease and secure this wire with a self tapping screw and ring terminal. BLACK w/...

Page 6 - Brake Switch Positive Shutdown Detail; PRESENTLY CONNECTED TO IN THE VEHICLE.; Switch

the Brown w/ Black trace wire to the output of the brake light switch. If the brake light switch in the vehicle switches ground,do not use the Brown w/ Black wire; see Grey w/ Black tracer wire. Brake Switch Positive Shutdown Detail YELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass OutputNOTE: ...

Page 7 - General Motors VATS By-Pass Diagram

LIGHT BLUE Wire: Ignition 3 / Shock Disable OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unit initializes,and remains grounded while running plus an additional 4 seconds after the Remote Start Unit turns off. In all of theapplications described...

Page 8 - DARK GREEN Wire: Tach Sensor Input; Tachometer Input Wiring Detail

DARK GREEN Wire: Tach Sensor Input This wire will continually monitor the engine tach rate while the unit is under power of the Remote Startmodule. This wire will be routed to the vehicle ECM tach input or through the firewall into the engine com-partment and connect to the negative side of the igni...

Page 9 - Wire Positive Switched Door Lock/Unlock Wiring Detail

3 Wire Positive Switched Door Locks:In this application, the Red wire of the two pin harness provides a + 12 volt pulse during the disarming sequence, orpulsed 12 volt unlock output. Connect the Red wire to the low current 12 volt signal wire from the factory door unlockswitch to the factory door un...

Page 10 - To program these selectable features:

10 1. RF Programmable Features: Feature Selection 1 Flash 2 Flash 3 Flash 4 Flash Default 1 Run Time 5 Min. 10 Min. 15 Min. 20 Min. 10 Min. 2 Ign. 2 During Crank Off On On 3 Light Output During Run Steady Flash Steady 4 Tach Mode NA Tach Tach 5 NA NA NA NA NA NA 6 Trouble Shooting Off On Off 7 Door ...

Page 11 - TESTING YOUR INSTALLATION:

11 Multi Coil Pack Adaptor: (Optional) The multi coil pack adaptor, (P/N 136B1400), is designed for use with vehicles that do not respond to single coil tachprogramming. Although the tach resolution of this circuit is designed to interface direct with most vehicles, there maybe an occasion where the...

Page 13 - KEY IN SENSOR CIRCUITS:

13 the equivalent reference wire in the vehicle you are installing the Audiovox Remote Start Unit in. 2. Connect the Cathode, (Striped) end, of a 4000 series diode to this reference wire.3. Connect the Anode, (Non Striped) end, of the diode to one side of the Remote Start enable switch.4. Connect th...

Page 15 - COMPLETING THE INSTALLATION:

15 COMPLETING THE INSTALLATION: After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety features of thesystem: 1. If you have not done so already, place the red rubber handle cover over the handle of the control switch for ease of identification. This will ...

Page 16 - WIRING DIAGRAM