Page 2 - PROTECTION WHILE THE SYSTEM IS ARMED
128-6456 2 of 18 NOTE: Your system has the option of using a siren, the vehicle horn, or both for thesounding device. Where the siren is referenced below, the horn or both may infact chirp, or beep. ARMING THE SYSTEM - ACTIVE1. Turn off the engine, exit the vehicle, and close all doors, hood lid, an...
Page 5 - MANUALLY OVERRIDING YOUR SYSTEM:; Programming Your Custom Override Code:; sequence. Turn the ignition switch to the on position.
128-6456 5 of 18 Page 5 2. Press and hold the valet push-button switch until the dash mounted LED, turns on. The LED will remain on as long as the system is in valet mode. 3. To return to normal operation, press and release the push button switch any time the ignition is on. NOTE: Always remember to...
Page 6 - Custom Code Programming Example:; beep and the lights will flash one time. LED turns On)
128-6456 6 of 18 Custom Code Programming Example: To Change the code from the factory pre-assigned code of 11 to “52” you would do thefollowing:1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. 2. Turn the ignition switch to the on position.3. Within 10 se...
Page 8 - SYSTEM FUNCTIONS AT A GLANCE; DASH LED INDICATORS
128-6456 8 of 18 © Audiovox Electronic Corp. 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-6456 APS-255CH SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 3 FLASH...PAUSE = INTRUSION ZONE 3 2 FLASH...PAUSE = INT...
Page 9 - Manuel de l’utilisateur; Système de sécurité télécommandé à 2 boutons avec détecteur
128-6456 9 of 18 MODÈLE APS-255CH Manuel de l’utilisateur Système de sécurité télécommandé à 2 boutons avec détecteur de vibrations en deux temps et désactivation du démarreur FONCTIONS : w Deux transmetteurs à trois boutons fonctionnant sur radiofréquence w Trois canaux de réception (système pouvan...
Page 11 - PROTECTION PENDANT QUE LE SYSTÈME EST ARMÉ
128-6456 11 of 18 þ La sirène émet une tonalité. Si la sirène ne fait retentir aucun son à l’armement, c’est parce que lafonction tonalités d’avertissement a été désactivée. Dans ce cas,consulter la section du manuel intitulée “ÉLIMINATION DES TONALITÉSD’ARMEMENT / DÉSARMEMENT”. o Les portes se verr...
Page 13 - DÉSARMER MANUELLEMENT VOTRE SYSTÈME:
128-6456 13 of 18 TANDIS QUE LE SYSTÈME RETENTITPendant un état d'alarme, vous souhaitent couper la sirène sans désarmer votre système desécurité, actionnez n'importe quel bouton d'émetteur autre que le bouton de désarmer. Cetteaction arrêtera la sirène laissera pourtant le système de sécurité entiè...
Page 14 - commutateur à bouton-poussoir de 1 à 9 fois.
128-6456 14 of 18 peut-être nécessaire si l'émetteur est perdu ou la batterie échoue, et votre système est armé.Ceci permettra à votre véhicule de fonctionner jusqu'à ce que vous ayez atteint votre desti-nation. Si comme indiqué à la dernière page de ce manuel, votre système de sécurité a été choisi...
Page 18 - RÉCAPITULATIF DES FONCTIONS DU SYSTÈME; INDICATEURS LUMINEUX — DEL DU TABLEAU DE BORD
128-6456 18 of 18 APS-255CH RÉCAPITULATIF DES FONCTIONS DU SYSTÈME INDICATEURS LUMINEUX — DEL DU TABLEAU DE BORD CLIGNOTEMENT RAPIDE = ARMEMENT PASSIF CLIGNOTEMENT LENT = SYSTÈME ARMÉ DEL ÉTEINTE = SYSTÈME DÉSARMÉ DEL ALLUMÉE EN CONTINU = MODE VALET 3 CLIGNOTEMENTS... PAUSE = EFFRACTION ZONE 3 2 CLI...