Audiovox ADV350S - Manuals - manualsarea.com

Page 2 - This DVD player incorporates two new features:

Important Notice An LCD panel and/or video monitor may be installed in a motor vehicleand visible to the driver if the LCD panel or video monitor is used forvehicle information, system control, rear or side observation ornavigation. If the LCD panel or video monitor is used for televisionreception, ...

Page 3 - MATERIALS INCLUDED IN THIS PACKAGE:

MATERIALS INCLUDED IN THIS PACKAGE: 1) ADV350 TV/Video Monitor with DVD (1pc)2) 12 Pin Power / Signal harness (P/N 112-3483) (1 pc)3) 2 Pin Power Wire Harness with choke (P/ N 112B3143) (1 pc)4) Hardware Package #4 x 3/8” Screws (9 pcs)#8 x 5/8” Self Drilling Screws (4 pcs)#8 Washers (4 pcs) 5) Remo...

Page 4 - GENERAL INSTALLATION APPROACH:; their respective locations.; GENERAL SYSTEM CONFIGURATIONS:; There are a few audio output options that can be added as follows:

GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Video Game, external amp, wireless headphones, VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups.3) Decide upon mounting loc...

Page 6 - MINI CONSOLE INSTALLATION:; Lowest point mark

MINI CONSOLE INSTALLATION: This page only covers special installation considerations for the mini-console installation. If the videomonitor is to be installed in a vehicle with the mini console, this console may need to be trimmed to fit thecontour of the vehicle headliner. 1) In this installation, ...

Page 7 - MOUNTING THE MINI-CONSOLE; Roof

-5- MOUNTING THE MINI-CONSOLE Roof Roof Support Headliner12”x9”x3/4” Plywood Block(4) Self-Tapping Screws (not supplied) Mini-Console Video Unit (5) #8 Flat Washers (5) #8x3/4” Self-Tapping Screws

Page 8 - Figure A; the main PCB and into the Mini-Din Connector on the main PCB.; Note; OPTIONAL; OPTIONAL

-6- ADV350 Figure A 1) Make the connections to the vehicle for the 12 pin wiring harness.2) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB. 3) Pull the wire tie loop tight and cut off th...

Page 9 - Positive Switched Dome lighting; CONNECTING THE DOME LIGHTS; Factory Dome light circuit

Positive Switched Dome lighting -7- CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are twocommon types of dome light circuits used, positive or negative switched. Positive systems supplyvoltage to the interior lights to turn t...

Page 10 - Negative Switched Dome lighting; connector

Troubleshooting: SYMPTOM: No power at Video Monitor P o w e r b u t n o v i d e o o rsound Picture, but no sound S t a t i c o n T V S t a t i o n s(Tuner Version Only) No Infrared remote func-tions for VCP (or other com-ponents) REMEDY: -Verify +12 VDC on Red wire at 2 pin Power Harness behind vide...