Audiovox 128-8549 - Manuals

Page 2 - YOUR “CODE HOPPING“ TRANSMITTERS

128-8549 2 of 24 Page 2  Protected Push Button Valet/Override Switch  7-Function LED-Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming  Intrusion Alert With Memory  Instant Siren Activation  Starter Disable Output  Additional Engine Immobilizer Output, (Optional Relay Required)  True L...

Page 3 - will not; ARMING THE SYSTEM - ACTIVE

128-8549 3 of 24 Page 3 known as a code grabber, which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system.Your Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then re...

Page 4 - PROTECTION WHILE THE SYSTEM IS ARMED

128-8549 4 of 24 Page 4  The dash mounted LED begins to flash slowly.  Parking Lights flash one time.  Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayeddome light learn circuit has been programmed and the system detected a openentry poi...

Page 5 - SILENT DISARMING

128-8549 5 of 24 Page 5  Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones.  Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle. NOTE: If the optional interior illumination circuit was insta...

Page 8 - ELIMINATING THE NORMAL ARM/DISARM CHIRPS

128-8549 8 of 24 Page 8 3. Within 10 seconds, press and release the PBLED switch, 3 times.4. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the lights will flash one time.) 5. Within 10 seconds, begin to press and release the PBLED switch to se...

Page 10 - grammed into your system.; PBLED SAFETY CONTROL SWITCH; serviced. To place the system in the service mode:; REMOTE STARTING THE VEHICLE; occurs. DO NOT remote start the vehicle if it is garaged.; To Remote Start The Vehicle:

128-8549 10 of 24 Page 10 1. Within 2 seconds of arming, press and release the ARM button 1 time, to defeat the pre-detect stage of the shock sensor. (The lights will flash and the siren will chirp once.) 2. Within 2 seconds of step 1, press and release the ARM button 2 times, to defeat the pre and ...

Page 12 - NOTE

128-8549 12 of 24 Page 12 NOTE : Option button used in combination is only available on the alternate re- mote transmitter and not available on the LCD Transmitter. OPTIONAL DEVICE OUTPUT ( CHANNEL 3 )Controlled By: Trunk/Key Button Other Transmitter button configurations are also available. Consult...

Page 13 - TURBO TIMER MODE

128-8549 13 of 24 Page 13 Controlled By:  Trunk/Key Button  Option Button  Lock + Unlock Buttons  Lock + Trunk/Key Buttons  Unlock + Trunk/Key Buttons Other Transmitter button configurations are also available. Consult your installa- tion center for other configurations not listed above that ma...

Page 14 - TRANSCEIVER ICONS AND THEIR INDICATIONS

128-8549 14 of 24 Page 14 With the turbo timer mode selected on, after you've arrived at your destination,while the engine is still running, set the parking brake, pause 2 seconds, then turnthe ignition switch to the off position. The engine will continue to run the allottedtime according to the sel...

Page 15 - ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:

128-8549 15 of 24 Page 15 When the Panic Mode has been activated and thesystem is armed the vehicle's lights will flash, thesiren and lock icon will be displayed on the LCDscreen and the siren will beep. If the system is disarmed and the Panic Mode is activated, the lights will flash unlock icon wil...

Page 18 - Parking Meter Counter:

128-8549 18 of 24 Page 18 set time. To toggle this feature off, press the option + lock buttons simulta- neously until a beep is heard and the 24 hr timer turns off. Note: the unit will start once and run for the prescribed time. If you require more frequent starting please refer to auto start up ti...

Page 20 - THIS PAGE LEFT BLANK INTENTIONALLY

128-8549 20 of 24 Page 20 THIS PAGE LEFT BLANK INTENTIONALLY

Page 23 - SYSTEM FUNCTIONS AT A GLANCE; DASH LED INDICATORS

128-8549 23 of 24 Page 23 APS 997N SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING/ACTIVE REARMINGSLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 3 FLASH...PAUSE = INTRUSION ZONE 3 2 FLASH...PAUSE = INTRUSION ZONE 2 1 FLASH...PAUSE = INTRUSION ZONE 1 SIREN...