Audiovox 128-7902A - Manuals

5 Cautions and Warnings Cautions and Warnings Cautions and Warnings Cautions and Warnings Cautions and Warnings 1. Do not install the Commander MT Display Controller in a position that hinders your view through the windshield, or obstructs viewingof the dashboard indicators and displays. 2. Do not i...

6 Commander MT Receiver Components Commander Commander Commander Commander Commander MT Receiver Kit Components MT Receiver Kit Components MT Receiver Kit Components MT Receiver Kit Components MT Receiver Kit Components 12 Vdc Power Cable CommanderMT Display Controller Remote Control X M Mini-Tuner ...

7 Installation/Wiring Precautions Installation/Wiring Precautions Installation/Wiring Precautions Installation/Wiring Precautions Installation/Wiring Precautions 1. To prevent a short-circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. Connect p...

8 Setting Up and Installing Y Setting Up and Installing Y Setting Up and Installing Y Setting Up and Installing Y Setting Up and Installing Your Kit our Kit our Kit our Kit our Kit NOTE: The XM ® signal can be received and processed virtually anywhere as long as there are no obvious satellite signal...

9 Cabling Interconnections Interconnect Diagram Interconnect Diagram Interconnect Diagram Interconnect Diagram Interconnect Diagram CommanderMT Display Controller DIN Opening Trim Bezel Interconnect Cradle with XM Mini-Tuner Power Cable with 2A In-line Fuse FM Direct Adapter XM Antenna To FM Antenna...

10 2. Important! It is very important to make your power connection to a source thatonly supplies 12V when the vehicle key is in the accessory or ignition ON position. A connection to a 12V source that is always on, regardless of the key position, can lead to a battery drain if the Commander MT Syst...

11 Caution: 1. Do not install the antenna inside the vehicle passen-ger compartment. Mounting the antenna in the passen-ger compartment either on the from dashboard, or onthe rear window deck area will cause reception issuesand must be avoided. 2. Mounting the antenna on a non-metalic surface willal...

12 • For antenna mounting locations at the rear of the roof, the antennacable can be routed into the vehicle through the trunk. Alwaysroute the cable under the weather seal near the lowest part of thetrunk to reduce possible water leaks. • Use pre-existing wiring channels created by the vehicle manu...

13 4. CommanderMT Display Controller Installation Be sure to locate your Display Controller below the top of the dashin your vehicle to keep the unit within easy reach while driving.Choosing a lower location in your installation should also make iteasier to manage the cables and achieve a more desir...

14 The Commander MT Display Controller can be installed using the DIN opening trim bezel or a snap-on mounting plate asshown below. The trim bezel permits in-dash or center consolemounting, while the mounting plate can be used with optionalcustom brackets, such as swivel or vent mounts. a. Using the...

15 b. Using the Snap-On Mounting Plate To attach the Commander MT cradle to optional mounting devices that are readily available at retail, attach the snap-on mountingplate to the rear of the Commander MT Display Controller as shown below. Examples of Optional Aftermarket Mounting Alternatives Displ...

16 5. Connection Options The Commander M T System provides an audio output signal in two ways: a. FM Direct Wiring - The FM direct adapter supplies a hard- wired FM output, provided the FM Frequency option of the XMMini-Tuner is turned on and tuned to an unused FM frequency. Interconnect Cradle with...

17 b. Low-Level Audio Output - For vehicle radio head units with auxiliary audio inputs, the audio signal can be routed throughan optional audio cable (Part No. SAT-RCA) and applied to theauxiliary inputs of a radio or entertainment system. In this case,to listen to the audio. the System Receiver FM...

18 6. Cable Routing and Component Installation Once you have established power connections, DisplayController and antenna placement, and audio connection, routeall cables to the location where you will mount the InterconnectCradle. When you have plugged the power and antenna jacksinto the cradle, re...

20 Warranty AUDIOVOX ELECTRONICS CORPORATION (the Company) warrants tothe original retail purchaser of this product that should, under normal useand conditions, be proven defective in material or workmanship within 12months from the date of original purchase, such defect(s) will be repairedor replac...