Page 2 - IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS To reduce risk of injury from fire or electric shock, always follow bask safety precautions when using this product. The safety symbol (exclamation point inside a triangle) on the Attendant ConnecT/R alerts you to the Important operat- ing and maintenance instructions b...
Page 3 - SAVE THESE INSTRUCTIONS
manual. If you cannot resolve the problem, or if the product is damaged, Call the AT&T Helpline at 1-800-628-2888. Do not open the product. Opening the product may exposeyou to dangerous voltages or other risks. 10. During thunderstorms, avoid using tele- phones except cordless models. There may...
Page 4 - Table of Contents
Table of Contents Introduction 1 Installation 3 Step 1— Mount the SPIRIT ® Attendant ConnecT/R 4 Step 2—Connect the SPIRIT Attendant ConnecT/R 5 Step 3—Test the Equipment 7 Troubleshooting 8 Appendix A—Wiring Requirements 9 Appendix B—Warranty 10 While reasonable efforts were made to ensure that the...
Page 5 - Introduction; SPIRIT
Introduction The following descriptions define important terms used in this manual. ● The SPIRIT Attendant is a device which provides automated call-handling capabili- ties for the SPIRIT Communications System. The SPIRIT ® Communications System Attendant ConnecT/R provides you with This Owner’s Man...
Page 6 - Figure 2. SPIRIT Attendant ConnectT/R Applications
2 Figure 2. SPIRIT Attendant ConnectT/R Applications
Page 7 - Installation; INSTALLATION INSTRUCTIONS
Installation 1. 2. INSTALLATION INSTRUCTIONS 3. Never touch uninsulated telephone wires or terminals unless the telephone line has been Never install telephone wiring during a disconnected at the network interface. Iightning storm. 4. Use caution when installing or modifying Never install telephone ...
Page 9 - Step 2 — Connect the SPIRIT Attendant
studs or cross members), partially screw the two screws into the wall at the marks, remove them, hang the tabs on the screws, and then tighten the screws. For plaster, plasterboard, cinder block, orbrick surfaces, drill a 3/16" hole at eachmark and insert an anchor into each of theholes. Gently ...
Page 11 - Step 3 — Test the equipment.; call to be answered by the SPIRIT Attendant.
NOTE: Use only a UL Listed wall plug-in power transformer that has Class 2 outputs and the following characteristics: Input rating: 99-127 V AC rms 60 llz 150 mA maximum 0utput rating: 27-35 V DC at 200 mA 14-18 V DC at 200 mA The power transformer supplied with the ConntecT/R has these characterist...
Page 12 - Troubleshooting; SPIRIT Attendant doesn’t respond to outside calls; SPIRIT Attendant doesn’t respond to intercom calls; SPIRIT Attendant ConnecT/R is very warm to the touch
8 Troubleshooting This section should help you determine the device operates. Call the AT&T Helpline at cause of problems you might encounter and 1-800-628-2888 if you need assistance. help you resolve them. Remember that the way your SPIRIT System was customized may influence how a particular O...
Page 13 - Appendix A — Wiring; Requirements
Appendix A — Wiring Requirements Note the following cabling requirements before 104386545). In addition, you will need a connecting the equipment. If these limits (which Building Entrance Protector, which can are the same ones that apply to our current house up to six 4C1S Block Protectors. SPIRIT S...
Page 14 - Warranty and
Appendix B — Limited Product Warranty and Limitation of Liability AT&T warrants that the product will be free from defects in material and workmanship for one year from the date of purchase. If the product becomes defective and such defect reported to AT&T within the one-year warranty period...
Page 15 - Index
Index AT&T Helpline 8 Controller 1C T R L R j a c k 6 Installation 3 Connect the ConnecT/R 5Connect the SPIRIT Attendant 6 Mount the ConnecT/R 4 Test the equipment 7 POWER jack 6Power Transformer 6 Safety Instructions 3SPIRIT Attendant 1 STATION jack 5 TEL DEVICE jack 6 T r o u b l e s h o o t i...
Page 16 - FCC Warning Statement
FCC Warning Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15of the FCC Rules. These limits are designed to provide reasonable protection against harmful Interference when theequipment is operated in a commercial environmen...