AT&T SB67128 - Manuals - manualsarea.com

Page 2 - Before you install; Parts list; Use only the power adapter supplied with this product. To obtain a

Before you install Parts list �B6��2� DECT 6.0 repeaterPower adapterPart � Important product informationPart 2 User’s manualPackage of screws ••••• Use only the power adapter supplied with this product. To obtain a replacement, visit our website at www.telephones.att.com or call 1 (888) 915-2007 . I...

Page 3 - About the repeater

You can use a repeater to extend the operating range for the AT&T �B6�� DECT 6.0 4-line corded/cordless telephone system to cover areas where the signal is very weak or not available. The repeater extends the range in all directions, even going around certain barriers. The telephone base, cord...

Page 4 - Registration

3 Registration You should register your repeaters to the telephone base before choosing locations for them in the building. NOTE: You can register a repeater to an �B6�� telephone base without deregistering it from a previous telephone base. New registrations overwrite any previous repeater regist...

Page 5 - STATUS indicator light

Registration STATUS indicator light Slow flash The repeater is powered on and in idle mode waiting to be re- registered. -OR- The registered repeater is not connected to the telephone base. -OR- Your telephone base has no power. Quick flash The repeater is registering to the telephone base. On The r...

Page 6 - Installation

Installation 5 After you have plugged in your repeaters in the locations you think are best, place a call from a cordless handset (AT&T �B6��0�) and while talking, move around the building to test the reception. You may want to adjust the position of repeaters to receive the best reception. Plug...

Page 7 - �ee page 2 for additional placement information.

Installation You can place the repeater on a tabletop. You can install your repeater on a wall or other object with the provided screws. Please use the recommended placement and installation tips as follows: The antennas needs to be in a high location (not on the floor or under a desk) for reception...

Page 9 - Troubleshooting; or call; STATUS; indicator light is on. If

Troubleshooting If you have difficulty operating this repeater, try the suggestions below. To contact Customer �ervice, purchase accessories or obtain replacement parts, visit our website at www.telephones.att.com or call 1 (888) 915-2007 . In Canada, dial 1 (866) 288-4268 . Please retain your recei...

Page 10 - indicator light is on when there is

Troubleshooting My repeater flashes slowly again after registration. First try all the suggestions on the previous page. Make sure the telephone base has power. •• My repeater cannot register to my telephone base. First try all the suggestions on the previous page. Make sure your telephone base is m...

Page 11 - General product care; DO NOT; expose it to direct sunlight or moisture.

General product care �0 To keep the repeater working and looking good, follow these guidelines: Avoid putting it near appliances and devices that generate electrical noise (motors, fluorescent lights, etc.) DO NOT expose it to direct sunlight or moisture. Avoid dropping the repeater.Clean with a sof...

Page 12 - Technical specifications; Repeater operating range

Technical specifications Channels 5 Operating temperature 32°F — �22°F 0°C — 50°C Repeater voltage (AC voltage, 60Hz) ��0 — �20 Vrms Repeater voltage (AC adapter output) 6VDC @600mA Repeater operating range This repeater operates within the maximum power allowed by the Federal Communications Commiss...