AT&T 1722 - Manuals - manualsarea.com

Page 2 - Before You Install; INSTALLATION

1 Strain-relief tab 1 Connect the telephoneline cord. 2 Connect the telephone (optional). 3 Connect the power cord. Standard Electrical Outlet ModularTelephoneJack Before You Install Choose a location for the answering systemnear a modular telephone jack and astandard electrical outlet not controlle...

Page 3 - Feature Setup; FEATURE SETUP; Feature Summary; SYSTEM

2 Feature Setup 1 To enter Feature Setup mode, press andhold S until the system announces “N UMBER OF RINGS IS …” 2 Press and release S until the system announces the feature you want to set. 3 Press and release a or r until the system announces the setting you want.Refer to the Feature Summary for ...

Page 4 - Feature Summary continued

3 Feature Summary continued FEATURE: SYSTEM OPTIONS: ANNOUNCES: ANNOUNCEMENT “A NNOUNCEMENT Choose ON to hear the announcement MONITOR MONITOR IS ...” when your system answers a call. ChooseOFF to have it silent on your end. (Yourcaller will still hear the announcement.) NOTE: Volume must be set to ...

Page 5 - Set the Clock; Record Your Announcement; Record a Memo; OPERATION

Set the Clock You must set the clock once so that thesystem announces the correct day and timewith your messages. After this, if yousubscribe to Caller ID, the system willautomatically reset the clock each time newcall information is received.Press P to exit at any time while setting the clock. 1 Pr...

Page 6 - Store Number

5 The system stops recording and resets to answer calls. If the system doesn’tdisconnect immediately, press and releasethe telephone switchhook. Caller ID Number Announce NOTE: For these features to work, you must subscribe to Caller Identificationser vice from your telephone ser viceprovider. There...

Page 7 - Message Window Display

6 Memory is Full When memory is full, or 100 messages havebeen recorded, the Message Window flashes F . Delete messages to make room for new ones.When memory is full, the system answerscalls after 10 rings, and sounds two beepsinstead of your announcement. Delete Messages Delete all messages — Hold ...

Page 9 - Connect with the Answering System; REMOTE OPERATION

8 Connect with the Answering System You can access many features remotely froma touch tone phone. 1 Dial your telephone number. 2 When the system answers, enter yourthree-digit Remote Access Code duringor after the announcement. The systemannounces the number of messages,then begins message playback...

Page 10 - ANSWERING SYSTEM OPERATION; PROBLEM SOLUTION; IN CASE OF DIFFICULTY

9 If you have difficulty operating this phone, try the suggestions below. For Customer Service, visitour website at www.telephones.att.com or call 1 800 222–3111 . Please retain your receipt as your proof of purchase . To purchase accessories or replacement parts contact Customer Service. Visit our ...