APC SUDP4000I - Manuals

APC SUDP4000I – Manual in PDF format online.

Manuals:

Manual

Manual APC SUDP4000I

Summary

Page 3 - About Your New UPS; Install PowerChute; UPS monitoring software. It provides; Troubleshooting; APC Contact Information

990-1007A, Revision 2 9/99 Smart-UPS DP Quick Reference Guide English About Your New UPS This Uninterruptible Power Supply (UPS) prevents blackouts,brownouts, sags and surges from reaching your computer andother valuable electronic equipment, filters out utility linefluctuations, and isolates your e...

Page 5 - Table of Contents

990-1007A, Revision 2 9/99 i Table of Contents Safety .........................................................................................................................................................................................................1 Handling Safety ..............................

Page 7 - Safety; Handling Safety; This equipment contains potentially hazardous voltages.; Replacement and Recycling of Batteries; User’s Manual

990-1007A, Revision 2 9/99 1 Safety This Safety Guide contains important instructions that should be followed during installation and maintenance of the APC equipment and batteries.It is intended for APC customers who setup, install, relocate, or maintain APC equipment. Handling Safety • Be careful....

Page 8 - Initial Inspection; Inspection; Refer to this

990-1007A, Revision 2 9/99 2 Initial Inspection Inspection Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage. The packaging is recyclable; save it forreuse or dispose of it properly. Unpacking Move the UPS, in its shipping package, as close to the desired location as pos...

Page 9 - Placement; To secure the unit in place; Installation Instructions; This function must be performed by qualified personnel only.; Checking Electrical Data; Switching Off

990-1007A, Revision 2 9/99 3 Placement S m a r t - U P S D P S m a r t - U P S D P S m a r t - U P S D P Install the UPS in a protected area that is free of excessivedust and has adequate air flow. Sufficient cooling must beensured by a minimum of 150 mm free space from theventilation slots on the b...

Page 10 - External Connections; Mains Connections; Make these connections only if no optional equipment (see the; Mains Fuses and Cable Dimensions; LOAD

990-1007A, Revision 2 9/99 4 External Connections Notes: As a standard, the Smart-UPS DP is made for single-phase connection. Due to the leakage current of 3.5 to 10 mA, the Smart-UPS DP must always be grounded according to local regulations. Mains Connections Make these connections only if no optio...

Page 11 - Rear Views

990-1007A, Revision 2 9/99 5 Rear Views F001 M ains F001 M ains 16) 15) 14) 13) 12) 11) 10) 9) 8) 7) 6) 5) 4) 3) 2) 1) A DC AH MIN. : STORED ENERGY TIME OU TPUT : INPUT : AH V DC / V / 2. REPL ACEMENT 1. REPL ACEMENT INSTALLED YEAR MONTH REPLACEMENT OF BATTERI ES KG. WEIGHT: S. NO.: TYPE: P.NO.: REC...

Page 12 - Common Fault

990-1007A, Revision 2 9/99 6 Common Fault The function of the common fault relay is factory preset. For changing the factory setting, please contact your local dealer. Principal Diagram (common fault) 1 NC 2 NO 3 Com 4 Com Data: Relay contacts - ohmic loadDC min./max.: 12V DC 20mA/60V DC 1A AC min./...

Page 13 - J100 EPO Relay PC Board; ISOLATED OPERATION; ISOLATED; NORMALLY CLOSED; EPO SHUTDOWN EXAMPLES

990-1007A, Revision 2 9/99 7 14 NC1 15 NC1 NO1 2 COM1 NO1 COM1 CHGND X005 EPO RELAY CONNECTOR 16 NC2 17 NC2 NO2 4 COM2 NO2 COM2 CHGND 18 NC3 19 NC3 NO3 6 COM3 NO3 COM3 CHGND 20 NC4 21 NC4 NO4 8 COM4 NO4 COM4 CHGND ON/OFF RELAY BYPASS OPERATION RELAY BATTERY OPERATION RELAY BATTERY LOW WARNING RELAY ...

Page 14 - Optional Equipment Installation; Galvanic Isolation Transformer; Galvanic Isolation Transformer Connections; UPS

990-1007A, Revision 2 9/99 8 Optional Equipment Installation Galvanic Isolation Transformer The galvanic isolation transformer can be delivered for one- or two-phase connection. When connecting a Smart-UPS DPand galvanic isolation transformer, the AC bus and the wires for the thermo switch must be m...

Page 16 - SBP is in the Bypass position.; Service Bypass Panel Connections

990-1007A, Revision 2 9/99 10 External Service Bypass Panel (SBP) Note: The Smart-UPS DP must only be connected by service bypass panels (SBPs) manufactured by APC. If SBPs other than those manufactured by APC are used, the UPS system may be damaged and the warranty given by APC is repealed. During ...

Page 17 - SBP and Galvanic Isolation Transformer Connections

990-1007A, Revision 2 9/99 11 UPS N L N L INPUT CABLE SBP MAINS L N PE LOAD L N OUTPUT CABLE SBP SBP L N L N Input cable UPS Output cable UPS Fm Fo 1 2 3 4 MBS CONTROL SBP CABLE X010 1 2 3 4 External Service Bypass Panel and Galvanic Isolation Transformer If both the external service bypass panel an...

Page 18 - External Run Battery Cabinet; Detail of Smart-UPS DP with an Extended Run Battery Cabinet

990-1007A, Revision 2 9/99 12 Standard System With Isolating Transformer (400 V) And SBP System Mains Fuse* (Fm) Input Cable Transformer Input Cable UPS Output Cable UPS 4kV 16A 3x2.5mm² 3x6mm² 3x6 mm² 6kV 25A 3x6 mm² 3x16 mm² 3x10 mm² 8kV 32A 3x10 mm² 3x16 mm² 3x10 mm² 10kV 40A 3x10 mm² 3x16 mm² 3x...

Page 19 - Operating Instructions; Switching On; Switching off the Smart-UPS DP must be done in the following way:; Setting the Voltage; power management; External Service Bypass Panel Operation; How to Switch From Normal to Bypass Mode

990-1007A, Revision 2 9/99 13 Operating Instructions Switching On F001 Mains Switch on the mains fuse on the rear of the UPS. The Smart-UPS DP will perform a self-check ending withthe LED display showing red/yellow/green, meaning that the unit is functioning properly. The unit performsa self-test au...

Page 20 - LEDs; The general meaning is:; LED DISPLAY

990-1007A, Revision 2 9/99 14 LEDs The LED bar on the front of the unit gives information by means of color and size of the bar. [ MUTE ] Batter y Oper. Check Batter y Green Yellow Normal Oper.Recharging Batt. [ 100 % ] [ 50 % ] [ 25 % ] [ 75 % ] Overload Red Bypass / Failure The general meaning is:...

Page 21 - Batteries; Automatic Battery Check; User’s Guide; . Once the battery is; Storage; Storage Conditions; Service; If the UPS requires service do not return it to the dealer!

990-1007A, Revision 2 9/99 15 Batteries Automatic Battery Check The battery test is automatically carried out every third month, if the automatic battery test function is set. The battery teststarts when the batteries are fully charged. There is no alarm given for the battery operation and the displ...

Page 23 - Regulatory Agency Approvals

990-1007A, Revision 2 9/99 17 Regulatory Agency Approvals N 394 B ME 61 geprüfteSicherheit

Page 24 - Internet

990-1007A, Revision 2 9/99 18 APC Contact Information Internet http://www.apcc.com Latin America, South America Argentina................ 0800.9.APCC (0800.9.2722) Mexico ............................... 95.800.804.4283 Brazil...................... 0800.12.72.21 Uruguay.............................. ...